Overview
The Rubicon Express RE1898-355 is an extended rear CVF drive shaft that pairs with the RE1807 and RE1801 slip yoke eliminator kits and with Currie Enterprises tail shaft conversion kits.
The shaft is universal fit, so set its length from your own driveline. Measure from the flange face to the center of the rear U-joint, with the slip stub centered in its travel and the vehicle in the running position on the ground.
Key features
- CV joint rear shaft
- Extended length
- Compatible with the RE1807 and RE1801 eliminator kits
- Compatible with Currie Enterprises tail shaft conversion kits
- Slip yoke eliminator required
Reading wear on a rear shaft
A rear driveshaft shows wear in a few predictable places. Vibration that rises with speed often points to a bent tube, a loose flange, or a worn joint. Check the tube for dents after hard landings, since even a small bend can unbalance the shaft at highway speed.
Clicking through a turn usually comes from the CV joint, while a clunk when shifting into gear can point to play in the slip or eliminator setup. Look at the joint boot, the flange bolts and the yoke for play before assuming the worst. Fixing a loose bolt is quick; a worn joint is not.
Note when the symptom appears: on acceleration, on deceleration, or only in turns. That detail helps narrow the cause before you start disassembly.
- Check the tube for dents after hard hits
- Listen for clicks during tight turns
- Re-tighten flange bolts after service
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1898-355 |
| UPC | 614901439687 |
| Joint type | CV |
| Length | Extended |
| Position | Rear |
| Fitment | Universal fit |
| Slip yoke eliminator | Required |
| Measured from | Flange face to center of rear U-joint |
Vehicle fitment
No vehicle is named. The shaft is universal fit, so the eliminator kit and driveline length determine whether it suits a build.
Confirm your vehicle’s year, model and trim before ordering, and check the eliminator kit before buying.

