Overview
The RE1898-175 is an extended rear CVF drive shaft made for the RE1801 and RE1807 slip yoke eliminator kit. It is a universal fit shaft, so the length must suit the vehicle it goes into.
It is measured center to center on the U-joint, with the slip stub at the center of its travel. Measure the vehicle on the ground in the running position so the shaft length suits your driveline.
Key features
- CVF rear drive shaft
- Extended length
- Made for the RE1801 and RE1807 slip yoke eliminator kit
- Requires a slip yoke eliminator
Working with CV joints
A CV joint allows steady rotation through a wider range of angles than a standard cardan joint, which is useful when a lifted or articulating suspension changes the driveline geometry. The joint still has limits, and running it past its angle range causes vibration and early wear, especially at higher speeds.
Good upkeep starts with the boot. A split or torn boot lets grit in and pushes grease out, and the joint then wears quickly. After trail use, wipe the boot, look for cracks, and check for play when you turn the shaft by hand. Keep the joint lubricated with a suitable joint grease.
Center-to-center measurement is only as good as the reference points. Mark the slip stub position and the axle height before you measure, so the number you use matches the way the vehicle sits.
- Look for boot splits after every trail day
- Feel for play in the joint by hand
- Replace a worn boot before the joint fails
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE1898-175 |
| UPC | 614901439519 |
| Joint type | CV |
| Length | Extended |
| Position | Rear |
| Fitment | Universal fit |
| Slip yoke eliminator | Required |
| Measured | Center to center on the U-joint |
Vehicle fitment
No vehicle is named for this universal fit shaft. It is intended for use with the RE1801 and RE1807 kit.
Confirm your vehicle’s year, model and trim before ordering, and check the length against your own measurement.





