Overview
The RE5015M is a spring-over axle conversion lift kit that moves the leaf spring perches to the top of the axle. It gives a net lift increase of 5.5 inches while using stock-height springs, which keeps the spring height close to factory. The kit suits builders who plan to do the conversion work carefully.
The kit includes spring perches, spring plates, brake lines and a drop pitman arm, along with instructions and hardware. Moving the perches means removing the original perches and welding the new ones in place. Steering modifications come with a spring-over conversion, and a CV-type drive shaft is recommended. The RE1445 and RE1444 Extreme-Duty leaf springs are the recommended pair for a total of 7 inches of lift.
Key features
- 5.5-inch net lift with stock-height leaf springs
- Spring-over conversion moves the perches to the top of the axle
- Spring perches and spring plates included
- Brake lines included
- Drop pitman arm included
- Mono tube shocks included.
- Instructions and hardware included
Planning a spring-over build
A spring-over conversion moves the leaf spring perches to the top of the axle, which lets the axle sit higher without taller springs. That keeps the spring rate and ride feel closer to stock, but it also changes pinion angle and the way the leaf packs load. Plan the build as a complete job rather than a single bolt-on change.
Welding is the most demanding step. The old perches come off and the new ones are welded to the axle, so the work should be done by someone who can weld cleanly on axle housings. Check perch alignment against the axle centerline before final welds, and inspect the spring plates for cracks before they are bolted in.
Steering geometry changes with the new arm and drop pitman arm, so a steering check is part of the build. Look at tie rod length, drag link angle and steering stop clearance once the axle is in its new position. A CV-type drive shaft is recommended because the driveline angle moves with the lift. Check brake hose length and routing after the lift is complete.
Mono tube shocks should be matched to the new axle position. Check shock length and mounting points so they do not bottom out at the new height.
- Weld perches with proper prep and inspection
- Check steering stop clearance and drag link angle
- Confirm the drive shaft suits the new driveline angle
- Recheck brake lines after the first drive
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE5015M |
| UPC | 614901452594 |
| Kit type | Spring-over axle conversion |
| Lift height | 5.5 inches net with stock springs (chart range 5 to 6.99 inches) |
| Included parts | Spring perches, spring plates, brake lines, drop pitman arm |
| Shocks | Mono tube, included |
| Recommended leaf springs | RE1445 and RE1444 Extreme-Duty for 7 inches total |
Vehicle fitment
This kit is for a leaf-spring axle converted to spring-over, so confirm your year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This conversion requires removing the original spring perches and welding new perches in place, plus other adjustments. Steering modifications are needed, and a CV-type drive shaft is recommended. Instructions and hardware are included with the kit.
What’s included
The kit includes spring perches, spring plates, brake lines, a drop pitman arm, mono tube shocks, instructions and hardware.
Converting to spring-over changes axle location and steering geometry, so steering and driveline should be checked after the work. Instructions and hardware are included to guide the install.


