Overview
The RE7133M is a 2.5-inch lift kit with Mono-Tube shocks, built around front and rear coil spring spacers. It lifts the Jeep JK enough to run 35-inch tires and acts as a leveling kit that removes factory rake. The front spacer is 2.5 inches and the rear spacer is 1-3/4 inches, which brings front and rear height closer together.
The kit adds brake line, bump stop and sway bar link extensions, plus a new rear track bar bracket. The maximum tire size is 35×12.50. Leveling the factory rake comes from the difference in spacer height, not from any other part of the kit.
Key features
- 2.5-inch lift height
- Front coil spring spacers and rear coil spring spacers
- Leveling effect that reduces the factory rake
- Bump stops
- Extended sway bar links
- Brake line and bump stop extensions
- New rear track bar bracket
- Maximum tire size of 35×12.50
Choosing spacers and tires
Coil spacers raise the body without changing the springs themselves, so the springs keep their original rate while sitting higher. Different front and rear heights help a JK sit more level, but they also change geometry at each axle. Measure the height before and after installation so the result can be compared with the starting point.
Tire size and wheel offset work together with a spacer lift. Wider tires can rub at full steering lock or in suspension compression, so test clearance with the tires you plan to run. Sway bar links and brake line extensions match the new heights, so keep those parts in the same job rather than swapping them one at a time.
Track bar brackets and bushings carry much of the lateral load after a lift, so inspect them at each service. Look for play at the bracket, cracked bushings and loose hardware. Mono-Tube shocks should be checked for leaks at the body and mounts, since a lift changes shock angles and loads.
- Measure ride height before and after the lift
- Test tire clearance at full lock
- Check the rear track bar bracket for play
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7133M |
| UPC | 70000662227 |
| Kit type | Economy spacer lift |
| Lift height | 2.5 inches |
| Front spacer | 2.5-inch coil spacer |
| Rear spacer | 1-3/4 coil spacer |
| Shocks | Mono-Tube |
| Maximum tire size | 35×12.50 |
Vehicle fitment
It fits the 2007-2018 Jeep Wrangler (JK). Check your year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The spacers are fitted at the coil springs, and the new rear track bar bracket changes the rear axle location, so the alignment should be checked after installation. Mono-Tube shocks are part of this version, so the shock installation follows the kit.
What’s included
The kit includes front and rear coil spring spacers, bump stops, extended sway bar links, brake line and bump stop extensions, a new rear track bar bracket and Mono-Tube shocks.
The front spacer is the larger of the two, and the rear spacer adds the smaller amount needed to bring the back of the vehicle closer to the front. The extended sway bar links and brake line extensions are included to go with the new spacer heights.
