Overview
The Rubicon Express RE7505M is a 5.5-inch Extreme-Duty long arm lift kit with a rear Tri-Link and mono tube shocks, made for the 1997–2002 Jeep Wrangler TJ. The lift falls within the 5 to 6.99-inch range.
The long arm system replaces the suspension with longer control arms, which Rubicon Express says improves geometry on a lifted Wrangler TJ. The company describes better stability, less torque roll and enhanced trail traction compared with standard short arm lifts.
The rear Tri-Link replaces the rear track bar, which lets the axle move straight up and down through its travel. The link adds anti-squat on steep climbs and improves on-road tracking. Mono tube shocks are included with this kit.
Key features
- 5.5 inch lift with a listed range of 5 to 6.99 inches
- Chromoly long arms made from 4130 chromoly tubing
- Rear Tri-Link in place of the rear track bar
- Builder Ball misalignment joint, rated for up to 32 degrees
- Adjustable control arms with serviceable Super-Flex spherical ball joints
- Mono tube shocks included
- Tuned lift springs, PT-Meg Super-Ride bushings and stainless steel brake lines
Mono tube shocks explained
Mono tube shocks use a single tube with a floating piston, which helps them resist fade when worked hard on a trail. On a lifted TJ they are often chosen for steep descents and rough sections, where the shock has to keep cycling without heating up. Their firmer feel on pavement is a trade-off worth weighing against how the vehicle is driven most days.
Shock length and mounting position should match the new control arm geometry at a higher lift. Check that the shock extends and compresses through its travel without binding, and that the eyelets sit square. A worn shock often shows as oil on the body, a bouncing ride or a clunk at the mounts.
- Look for oil on the shock body
- Check eyelets and bushings during service
- Replace shocks in pairs on each axle
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7505M |
| UPC | 614901452945 |
| Lift height range | 5 to 6.99 inches |
| Suspension type | Long arm |
| Kit type | Extreme-Duty long arm |
| Rear lift method | 3-link (Tri-Link) |
| Control arm material | 4130 chromoly, .250 wall |
| Misalignment joint | Builder Ball, up to 32 degrees, 3 inch OD housing |
| Belly pan | Three-piece, for transfer case and transmission access |
| Shocks included | Yes, mono tube |
| Fitment | Direct fit |
Vehicle fitment
It fits the 1997–2002 Jeep Wrangler (TJ), including the SE, Sahara and Sport models.
Confirm your vehicle’s year, model and trim before ordering, including whether it is a 2003–2006 TJ, JK or YJ.
Installation notes
At 5 to 6.99 inches of lift, the alignment and driveline angles need checking after installation. The kit is bolt-on for factory Dana 35 and Dana 44 rear ends.
What’s included
The kit includes front and rear control arms, the rear Tri-Link, the Builder Ball, PT-Meg Super-Ride bushings, tuned lift springs, stainless steel brake lines, mono tube shocks and a three-piece belly pan.


