Overview
The Rubicon Express 3.5 Inch Extreme-Duty Long Arm Lift Kit with Rear Track Bar and Mono Tube Shocks (part number RE7203M) is a long arm suspension lift for the Jeep TJ. Its listed lift height range is 3 to 4.99 inches, and it comes with mono tube shocks.
Longer control arms are the core of this long arm design. The change in geometry on a lifted TJ is intended to add stability, cut torque roll and improve traction on the trail.
Mono tube shocks use one tube with a separate piston, a design many drivers choose for steady damping over repeated bumps. The stainless brake lines in this kit should be routed clear of the new control arms and the track bar.
Key features
- Chromoly long arms
- PT-Meg Super-Ride bushings
- Adjustable control arms with serviceable Super-Flex spherical ball joints
- Tuned lift springs
- Mono tube shocks included
- Rear track bar included
- Front and rear stainless brake lines included
- Three-piece belly pan
Planning the long arm install
A long arm install goes better with a plan. Lay out the arms, bushings, springs and hardware on a bench and confirm every piece is present before the vehicle comes apart. Work through one side at a time so the other side stays as a reference for bolt positions and spring placement.
Plan the alignment early. The arms change caster, camber and toe, so the job is not finished until the front and rear are set. Ask the shop to check the thrust angle as well, since the rear track bar and the arms work together to keep the axle centered. After the first few trail outings, check tire wear and the belly pan mounts.
- Lay out all hardware before starting
- Mark the factory arm positions for reference
- Torque bushing bolts with the suspension at ride height
- Recheck the belly pan after rock runs
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7203M |
| Lift height range | 3 to 4.99 inches |
| Suspension type | Extreme-Duty long arm |
| Rear lift method | Coil springs |
| Shock absorbers | Mono tube, included |
| Brake lines | Front and rear stainless |
| Fitment type | Direct fit |
Vehicle fitment
The kit fits the Jeep TJ, covering the 1997–2006 Wrangler (TJ) with no trim narrowing. LJ, JK and JL Wranglers fall outside this fit. Check your vehicle’s year, model and trim before ordering.
The LJ and the JK and JL Wranglers are not covered by this kit. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Because the stainless brake lines are included, the brake lines are replaced as part of the job. Check the alignment and the driveline angles once the long arms are installed.
What’s included
Chromoly long arms, PT-Meg bushings, Super-Flex spherical ball joints, tuned lift springs, mono tube shocks, a rear track bar, front and rear stainless brake lines and a three-piece belly pan.


