Overview
The Rubicon Express RE7514T is a 4.5 inch Extreme-Duty long arm lift kit with a rear Tri-Link and twin tube shocks for the 2003–2006 Jeep Wrangler TJ. The lift height range is 3 to 4.99 inches, and the shocks are included.
The long arm conversion swaps the stock arms for longer control arms. On a lifted TJ this geometry adds stability, reduces torque roll and improves trail traction compared with a standard short arm lift.
The Tri-Link replaces the rear track bar so the axle can move up and down freely, and it adds anti-squat for steep climbs. The kit also uses the Builder Ball, which Rubicon Express describes as its newest misalignment joint.
Key features
- Chromoly long arms built from 4130 chromoly tubing
- Rear Tri-Link that replaces the rear track bar
- Builder Ball misalignment joint, rated by Rubicon Express for up to 32 degrees
- Adjustable control arms with serviceable Super-Flex spherical ball joints
- Twin tube shocks included
- Tuned lift springs and PT-Meg Super-Ride bushings
- Stainless steel brake lines
Choosing a long arm setup
Long arm kits move the control arm pivots outward, so the axle keeps a steadier arc through its travel. That matters most on a lifted Wrangler that sees rock ledges, ruts and washouts, where the arms take hard hits and the axle needs room to articulate. Think about how you use the Jeep before buying: highway-heavy driving favors steady tracking, while frequent rock crawling puts more load on the joints and mounts.
Because the rear Tri-Link takes the place of the track bar, review any steering or axle components that relied on the old bar before the install. Inspect control arm bushings and ball joints after hard days on the trail, and replace any joint that shows play, cracking or a torn boot. Plan a driveshaft check at the same visit.
- Check bushing condition at each oil change
- Re-torque bolts after the first trail runs
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7514T |
| UPC | 614901453249 |
| Lift height range | 3 to 4.99 inches |
| Suspension type | Long arm |
| Kit type | Extreme-Duty long arm |
| Rear lift method | 3-link (Tri-Link) |
| Control arm material | 4130 chromoly, .250 wall |
| Misalignment joint | Builder Ball, up to 32 degrees, 3 inch OD housing |
| Belly pan | Three-piece, for transfer case and transmission access |
| Shocks included | Yes, twin tube |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2003–2006 Jeep Wrangler (TJ), including the 65th Anniversary Edition, Rubicon, SE, Sahara and Sport models.
Fit covers 2003–2006 TJ models only. Check model year and trim against your vehicle before buying.
Installation notes
A long arm conversion changes alignment and driveline angles, so both should be checked after installation. The kit bolts on to factory Dana 35 and Dana 44 rear axles.
What’s included
The kit includes front and rear control arms, the rear Tri-Link, the Builder Ball, twin tube shocks, tuned lift springs, PT-Meg Super-Ride bushings and stainless steel brake lines.







