Overview
The Rubicon Express JT7141T is a 2.5/3.5 inch standard suspension lift kit with twin tube shocks for the 2020–2026 Jeep Gladiator JT. Coverage spans the Gladiator trims detailed further down.
The rear lift uses coil springs, with a lift height range of 0 to 3.5 inches. Twin tube shocks at the front and rear are included, and the tire size is 35 inches.
It is a bolt-on upgrade that increases ground clearance and extends wheel travel. It makes room for 37-inch tall tires, and no driveshaft or exhaust or brake line changes are needed.
Key features
- 2.5/3.5 inch standard suspension lift
- Twin tube shocks at the front and rear, included
- Coil spring rear lift method
- Increased ground clearance and extended wheel travel, per the brand
- Room for 37-inch tall tires after install.
Twin tube shock basics
Twin tube shocks are a common design for coil spring lifts, using an inner and outer tube to manage fluid flow through compression and rebound. They are generally simpler to service than some alternatives, but their damping is set for the spring rate and ride height they were built for. Keeping the shock within its operating range helps it control the body without wearing out early.
Look for signs of wear such as fluid leaking down the body, a noticeable knock over bumps, or a bouncy ride that does not settle. Check the mounting eyes and bushings at each service, and replace any cracked or hardened bushings. After a lift, check the shock length at full droop and full compression before heading off road.
- Oil seepage at the shock body
- Knocking over bumps
- Bouncy ride that does not settle
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | R/EJT7141T (JT7141T) |
| Kit type | Standard suspension lift kit |
| Lift | 2.5 to 3.5 inch |
| Lift height range | 0 to 3.5 inches |
| Tire size | 35 inches |
| Front shocks | Twin tube |
| Rear shocks | Twin tube |
| Rear lift method | Coil springs |
| Rear lift component | Coil spring |
| Shocks included | Yes |
| Fitment type | Direct fit |
Vehicle fitment
The 2020–2026 Jeep Gladiator is covered in the 80th Anniversary, High Altitude, Launch Edition, Mojave, Overland, Rubicon, Sport, Sport S, Willys and Willys Sport trims.
Only the Gladiator JT from 2020 through 2026 is listed, so Wrangler and earlier Gladiator years are outside this fitment. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Twin tube shocks at both ends should be checked for length once the kit is in, and the alignment should be set after the lift is complete.
What’s included
Twin tube shocks at the front and rear come with the coil spring rear lift and the standard suspension components.
















