Overview
The Rubicon Express RE7525M is a 5.5 inch Extreme-Duty long arm lift kit with a rear Tri-Link and mono tube shocks for the 2004–2006 Jeep Wrangler LJ Unlimited. The lift height range is 5 to 6.99 inches, and it is a direct fit for those models.
This LJ long arm kit replaces the factory arms with longer control arms, making it a complete suspension replacement. The design aims for better lifted geometry, more stability on and off road and reduced torque roll.
The rear Tri-Link replaces the rear track bar and lets the axle travel straight up and down. The kit includes mono tube shocks, so the shock replacement is handled with the lift.
Key features
- 5.5 inch lift with a listed range of 5 to 6.99 inches
- Chromoly long arms built from 4130 chromoly tubing
- Rear Tri-Link in place of the rear track bar
- Builder Ball misalignment joint, rated for up to 32 degrees
- Adjustable control arms with serviceable Super-Flex spherical ball joints
- Mono tube shocks included
- Tuned lift springs and PT-Meg Super-Ride bushings
Tri-Link maintenance
The Tri-Link carries the axle’s lateral and longitudinal loads in place of the rear track bar, so its bushings and ends work harder than a stock link would. Inspect them at regular service intervals and after hard off-road use. Look for play at the bushings, cracked rubber, bent brackets and loose hardware around the frame and axle mounts.
Because the link is part of the axle location, wear there shows up as wandering on the highway or clunking over bumps. Address play early rather than waiting for a noise. Retighten fasteners to proper torque after the first trail runs, and keep the mounting brackets free of rust.
- Check Tri-Link bushings for play
- Inspect brackets for cracks or bends
- Retighten hardware after the first trail runs
- Look for rust at the frame mounts
Specifications
| Brand | Rubicon Express |
|---|---|
| Part number | RE7525M |
| UPC | 614901452983 |
| Lift height range | 5 to 6.99 inches |
| Suspension type | Long arm |
| Kit type | Extreme-Duty long arm |
| Rear lift method | 3-link (Tri-Link) |
| Control arm material | 4130 chromoly, .250 wall |
| Misalignment joint | Builder Ball, up to 32 degrees, 3 inch OD housing |
| Shocks included | Yes, mono tube |
| Fitment | Direct fit |
Vehicle fitment
It is for the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon models.
It does not fit the standard two-door Wrangler LJ, the TJ or the JK. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Installing this lift changes alignment and driveline angles, so verify both afterward. The kit bolts to factory Dana 35 and Dana 44 rear axles.
What’s included
The kit includes front and rear control arms, the rear Tri-Link, the Builder Ball, mono tube shocks, tuned lift springs, PT-Meg Super-Ride bushings and a three-piece belly pan.


