Overview
The Fox 2.0 Factory Series Bump Stop has a 1-1/4 in. shaft, a black/zinc finish, 9.66 in. extended and 7.65 in. collapsed lengths, and a 2.01 in. stroke. It is a universal fit design, so the shaft diameter and lengths decide whether it suits your mount or shock.
A bump stop limits how far a suspension can compress, so the shaft diameter, length and stroke need to suit the mount or shock it works with. Fox has made shocks for 30 years and builds its suspension products for high performance trail and track use.
Key features
- Fox 2.0 Factory Series design
- 1-1/4 in. shaft
- Black/zinc finish
- Extended 9.66 in., collapsed 7.65 in., stroke 2.01 in.
- Universal fit design
Before you buy
Bump stops work at the end of suspension travel, so their job is to absorb the last part of compression before the axle or frame meets the body. A stop that is too short allows harsh contact, while one that is too long can keep the suspension from reaching its intended range. Because the stop is one part of a larger system, check its position against the shock body, the mount and any spring seat before fitting.
Bump stops are often replaced along with the dust boot and mount bushings, especially when the old part has cracked or flattened. Look for splits, crumbling, flat spots or metal that has worked loose. When the shock is serviced, inspect the stop at the same time and recheck the fasteners after the first few drives on rough ground.
- Check the shaft diameter against the existing mount
- Note any cracks or flattened areas on the old stop
- Replace the dust boot if it is torn
Specifications
| Brand | Fox Racing Shox |
|---|---|
| UPC | 700006894641 |
| Shaft diameter | 1-1/4 in. |
| Finish | Black/Zinc |
| Dimensions | 2.0 X 2.0 |
| Extended length | 9.66 in. |
| Collapsed length | 7.65 in. |
| Stroke | 2.01 in. |
Vehicle fitment
No vehicle is named for this bump stop. Fox marks it Universal Fit, but the shaft diameter and lengths must match the mount or shock it replaces, so compare them with your existing parts first.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure your existing bump stop and mount before fitting, comparing the 1-1/4 in. shaft and the 9.66 in. and 7.65 in. lengths. A bump stop that is too long or too short can change how the suspension behaves at full compression.
What’s included
Fox names the bump stop only. No mounting hardware or other parts are mentioned.






