Overview
The RockJock 4×4 CE-ACOSR is a rear coil over spring adjuster for the 2004–2006 Jeep Wrangler LJ. It uses a two-piece threaded upper bump stop, so the owner can raise or lower the rear height of the vehicle by turning the upper section.
The kit includes a polyurethane bump stop and a spring resting pad. The adjuster changes rear height only and is built for the LJ trims covered under Vehicle fitment.
Key features
- Two-piece threaded upper bump stop
- Raises and lowers the rear height
- Polyurethane bump stop included
- Spring resting pad included
- Hydraulic bump type, per the manufacturer
Measuring and setting rear height
A threaded upper bump stop changes the rear height by moving the stop relative to the coil spring. Measure the rear height before making any change, and record the reading so you can return to a known setting. Make small adjustments and measure again, since a few turns can change the height more than expected.
Changing rear height also changes the spring seat position, the shock angle and the suspension travel before the stop engages. Check that the coil spring stays seated and that the shocks have enough length at full extension. A height change at the rear can affect driveshaft angle, so inspect the driveline after the change.
- Measure rear height before and after each change
- Make small adjustments and recheck
- Confirm the spring stays seated
- Inspect driveshaft angle after changes
Specifications
| Brand | RockJock 4×4 |
|---|---|
| Part number | R/JCE-ACOSR |
| Position | Rear |
| Adjustment | Threaded upper bump stop |
| Includes | Polyurethane bump stop and spring resting pad |
| Fitment | Direct fit |
Vehicle fitment
It fits the 2004–2006 Jeep Wrangler LJ in its Unlimited and Unlimited Rubicon trims.
Confirm fit for your vehicle’s year, model and trim before ordering, including any Jeep TJ application.
Installation notes
The threaded upper bump stop sets the rear height, so the height should be measured before and after the change. Because the adjuster works on the coil spring, the spring’s position and the rear suspension travel should be checked after the install.









