Overview
The ReadyLift 69-1036 is a 2.5-inch front and 1.5-inch rear SST lift kit for the 4WD Ram 1500 from 2009 through 2018. It is a complete front and rear lift system with a steel top mount strut extension at the front and steel coil spring spacers at the rear. It covers 2009 and 2010 Dodge Ram 1500 models and 2011 through 2018 Ram 1500 models in a wide range of trim levels.
The kit adds heavy duty DOM tube steel upper control arms with corrected ball joint cup angles and heavy duty ball joints, which ReadyLift says are the same ball joints used on its heavy duty trucks. Fabricated steel top mount strut extensions provide the 2.5 inches of front lift, and the steel coil spring rear spacers provide 1.5 inches at the rear.
Key features
- 2.5 inches of front lift from fabricated steel top mount strut extensions
- 1.5 inches of rear lift from steel coil spring spacers
- Heavy duty DOM tube steel upper control arms
- Corrected ball joint cup angles and heavy duty ball joints
- Bump stop extensions
- One-time grease control arm bushings
- Up to 35×11.50 tires on 9-inch wheels with +12 offset
Choosing the right setup
Upper control arms carry load through the front suspension, and replacing them is often the point where a lift becomes a bigger job. Heavy duty arms and ball joints hold the wheel in position under braking and off-road loads, so the joints should be checked for play before and after the install. Pay attention to how the strut extensions change the angle of the front axle, since that affects steering feel and tire wear.
On a truck that has been worked hard, the rear springs and shocks often wear at the same time as the front. Replacing worn rear shocks while the rear is open keeps ride quality balanced with the new height. Also plan for bump stop clearance and brake line length, and recheck the steering components at the first service interval.
- Inspect ball joints and control arm bushings for play
- Replace worn rear shocks while the rear is accessible
- Check brake line length and steering component clearance
- Re-torque fasteners after the first highway and trail runs
Specifications
| Brand | ReadyLift |
|---|---|
| Part number | RDY69-1036 |
| Front lift | 2.5 inches |
| Rear lift | 1.5 inches |
| Upper control arms | Heavy duty DOM tube steel |
| Ball joints | Heavy duty |
| Front lift component | Fabricated steel top mount strut extension |
| Rear lift component | Steel coil spring spacer |
| Tire fit | 35×11.50 on 9-inch wheel, +12 offset |
| Drive type | The kit is built for 4WD trucks. |
| Fitment type | Direct fit |
Vehicle fitment
It fits 2009 and 2010 Dodge Ram 1500 Laramie, SLT, ST, Sport, TRX and TRX4 models, and 2011 through 2018 Ram 1500 models in Big Horn, Express, HFE, Laramie, Limited, Lone Star, Rebel, SLT, Tradesman and Special Service versions.
It does not fit 2019 and later Ram 1500 trucks. Confirm the drive type, year, model and trim before ordering.
Installation notes
Replacing the upper control arms and adding strut extensions changes front geometry, so have the caster and camber checked with an alignment after installation. The one-time grease control arm bushings are fitted with the arms. No permanent modifications are needed.
What’s included
The kit includes the heavy duty DOM tube upper control arms with ball joints, the fabricated steel top mount strut extensions, the steel coil spring rear spacers, the bump stop extensions and the one-time grease control arm bushings.









