Overview
The G2 Axle and Gear Chrysler 9.25-inch ZF rear master ring and pinion install kit, part number 35-2028B, is a master kit for the Chrysler 9.25-inch ZF rear axle. It includes a factory ring and pinion.
Because the gear set is included, it gives a more complete starting point than a kit without gears, though other contents need checking before installation.
Setting up a master kit
A master kit is a complete starting point, with the gear set, pinion bearings and setup parts grouped together for a full rebuild of the carrier. On a Chrysler 9.25-inch ZF rear axle, the ring gear and pinion must be matched exactly, so a factory gear pair keeps the set consistent. Replacing the pinion bearings, carrier bearings and seals alongside the gears is common, because worn bearings can change the setup after a short run.
Before installing, check the axle housing, the carrier bearing seats and the pinion depth shim position. Gear setup needs correct pinion depth and backlash, and experienced technicians use specialized measuring tools to confirm them. After the first short drives, recheck fasteners and listen for changes in noise, then keep the fluid at the level and type your axle requires.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 35-2028B |
| UPC | 631410116632 |
| Kit type | Master, rear |
| Axle | Chrysler 9.25-inch ZF |
| Gear set | Factory ring and pinion |
Vehicle fitment
It is for the Chrysler 9.25-inch ZF rear axle. Confirm fit for your vehicle’s year, model and trim before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Setting pinion depth and preload on a kit with a factory ring and pinion calls for an experienced gear technician and the proper measuring tools.
What’s included
It includes a factory ring and pinion. Not included: Confirm any further parts you need, such as seals and hardware, before starting the install.









