Overview
The Pro Comp 51036B is a front upper control arm with stainless steel Uniball joints and a billet dust cap, sold as a pair for 2014 and newer GM 1500 trucks. Pro Comp names this version for models with stamped steel or aluminum suspension, and it is the newer-generation counterpart of the 51035B arm for 2007 to 2014 trucks.
Pro Comp says factory upper arms on these trucks have weak ball joints and are not built for off-road use. The arm uses 1.25-inch chromoly tubing, reinforced pivot bushing mounts and large PTMEG pivot bushings to limit flex under heavy suspension cycling, and it is intended for lifted, leveled or stock trucks.
The arm uses the same 1.25-inch chromoly tubing and reinforced mounts as the 51035B. This version is made for models with stamped steel or aluminum suspension, so confirm your truck’s suspension design before ordering.
Key features
- Stainless steel FK Uniball joints
- Heavy-duty chromoly tubular construction
- Reinforced pivot bushing mount
- Large PTMEG pivot bushings with zerk fittings
- Billet machined dust cap
- Black powder coat finish
Matching arms to suspension design
Factory suspensions differ across model years, and the upper arm mounts and geometry change with them. Before choosing a replacement arm, identify the suspension design on your truck, since an arm built for one layout may not seat correctly on another.
Upper arms with stainless steel ball joints and chromoly tubing are often paired with new lower joints and bushings during a front-end refresh. Alignment is a must after any arm change, because caster and camber shift when the arm angle changes.
Check the arm regularly for bent tubing, cracked welds and worn bushings. Grease the fittings on schedule and inspect the dust caps so grit does not reach the ball joint.
- Identify your truck’s suspension design first
- Replace lower joints or bushings together if worn
- Align the front end after installation
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 51036B |
| UPC | 614901273618 |
| Position | Front upper |
| Ball joints | Stainless steel FK Uniball |
| Tubing | Heavy-duty chromoly, tubular, 1.25 inch |
| Bushings | PTMEG pivot bushings with zerk fittings |
| Dust cap | Billet machined |
| Finish | Black powder coat |
| Sold as | Pair |
Vehicle fitment
The arm is made for 2014 and newer GM 1500 trucks with stamped steel or aluminum suspension. Confirm that your truck is a GM 1500 from 2014 or later before ordering.
Trucks from 2007 to 2014 use the 51035B arm, not this one. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Changing upper control arms affects caster, camber and steering geometry, so schedule an alignment after the install. The pivot bushings are fitted with zerk fittings and should be greased once the arms are in place.
What’s included
Two upper control arms, sold as a pair, each with a billet machined dust cap.
































