Overview
The Pro Comp ZX2065 is a rear Pro Runner monotube shock absorber for the 2004–2006 Jeep Wrangler (LJ), including Unlimited and Unlimited Rubicon, and the 1997–2006 Jeep Wrangler (TJ). It is designed for a 1.5 inch lift. The shock extends to 19.70 inches with 6.65 inches of travel, and it uses loop mounts at both ends.
The body is a gas-charged monotube pressurized with nitrogen, which helps prevent cavitation when the shock compresses and rebounds. The design sheds heat more efficiently than a twin-tube hydraulic shock. Valving is multi-stage and set for each application, and a boot covers the shaft.
The ZX2065 is a rear shock with loop mounts at both ends, so the mounting check is straightforward: compare the loop eyes on the shock with the brackets on the Wrangler rear axle. Its 19.70 inch extended length is the figure to measure against the installed length of the original shock before ordering.
Key features
- Rear position, direct fit
- Gas charged monotube with nitrogen pressurization
- Multi-stage valving tuned to the application
- Loop upper and lower mounts
- Zinc plated, clear coated finish
Choosing the right rear shock
Rear shock choice comes down to three things: mount style, lift height and installed length. Loop mounts at both ends need brackets that accept an eye, and the shock’s extended length should match the old unit at the same ride height. Matching these details before buying avoids shocks that bind at full compression or run out of travel early.
A single shock can be replaced on its own, but paired shocks give more even damping from side to side. Check the bump stops on the same axle while the shock is off, and inspect the loop bushings for wear. A shock that makes noise or leaks oil should be replaced rather than repaired.
- Match mount style before buying
- Compare installed length at the same ride height
- Inspect loop bushings for wear
- Check bump stops on the same axle
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | ZX2065 |
| UPC | 614901024685 |
| Shock series | Pro Runner |
| Position | Rear |
| Lift height | Designed for a 1.5 in. lift |
| Extended length | 19.70 in |
| Collapsed length | 13.06 in |
| Travel length | 6.65 in |
| Upper mount | Loop |
| Lower mount | Loop |
| Body | Monotube, gas charged |
| Adjustable | No |
| Remote reservoir | No |
| Finish | Zinc plated, clear coated |
| Boot | Included |
Vehicle fitment
It fits the 2004 to 2006 Wrangler LJ and the 1997 to 2006 Wrangler TJ, designed for a 1.5 inch lift.
Wrangler JK and JL models are not covered by this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shock has loop mounts at both ends, so the bracket on the Wrangler frame and axle must accept a loop eye. Check the clearance at full compression with the 1.5 inch lift installed before driving.
What’s included
One rear Pro Runner monotube shock with boot, sold as each.



























