Overview
The Pro Comp Suspension PR2061 is a rear PRO-M monotube shock for a 4 inch lifted Wrangler. Sold one per order, it fits the 1997 to 2006 Wrangler TJ and the 2004 to 2006 Wrangler LJ.
Nitrogen gas charge and a floating piston separate oil from gas in this shock. The multi-stage valving is tuned for the application, and the body carries extra oil to dissipate heat.
Key features
- Rear monotube design for a 4 inch lifted Wrangler
- Extended length 23.5 inches, collapsed length 15.3 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Rear shock wear on a Wrangler
A rear shock on a Wrangler works through a long range of axle movement, so it is one of the first parts to show wear on trail use. A four inch lift changes the rear ride height, which means the installed length should match the lift before the shock is fitted. Check the frame and axle clearance at full droop as well as full compression, since the shock body moves through both.
Look for oil on the shock body, a clunk or knock over rocks, and loose loop mounts after a hard trail day. Bushings and the boot should be inspected at each oil change, since grit that gets past the boot can damage the shaft. Replacing rear shocks in pairs keeps the rear axle controlled on both sides, which helps the Wrangler track straight on uneven ground.
- Check clearance at full droop and full compression
- Tighten loop mounts after the first trail run
- Inspect the boot for cracks
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2061 |
| Shock series | PRO-M |
| Position | Rear |
| Extended length | 23.5 in |
| Collapsed length | 15.3 in |
| Upper and lower mount | Loop |
| Lift | 4 in |
| Finish | Silver powder coat |
Vehicle fitment
Wrangler TJ fitment covers the 1997 to 2006 TJ, including 65th Anniversary Edition, Rubicon, SE, Sahara, Sport and X models, plus the 2004 to 2006 LJ, including Unlimited and Unlimited Rubicon.
It is designed for the TJ and LJ generations only. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Compare the 23.5 inch extended and 15.3 inch collapsed lengths with the rear shock being replaced, since a 4 inch lift changes the rear ride height on a Wrangler. The mounts should be checked against the factory brackets, which differ between the TJ and LJ. Confirm the shock clears the axle and the frame through full travel and inspect the boot after installation.
Confirm the 4 inch lift on your Wrangler before ordering, since the shock’s length is set for that height. Check the mounts against the factory brackets, and make sure the shock body clears the axle and frame through full compression.
Confirm the shock clears the frame and the rear axle at full droop and full compression, and check that the mounts are seated fully.
The finish is silver powder coat, and each item covers one shock.
What’s included
One PRO-M rear monotube shock with polyurethane boot under part number EXPPR2061.









