Overview
The Pro Comp PRO-M monotube rear shock, part number EXPPR2045 (model PR2045), is a nitrogen gas charged shock for vehicles with 0 to 2 inches of lift. It is sold individually.
The PRO-M has an internal floating piston that separates the oil from the nitrogen gas charge, which Pro Comp says prevents the cavitation that robs performance. Multi-stage valving is set for each application. The 2.0-inch body holds more oil, which Pro Comp says helps heat dissipation on off-road runs. A redesigned wiper seal is meant to keep the shock from leaking, and the silver powder coat finish is paired with a polyurethane boot. Pro Comp built the PRO-M to handle off-road use and still deliver a smooth ride on the road. The shaft is a 14mm chrome hardened design, and the upper and lower mounts are both loops. The 24.8-inch extended length and 15.9-inch collapsed length are the figures to match against your current shock. Pro Comp specifies vehicle specific valving, so the damping is set for the application the shock is sold for.
Key features
- Monotube design with an internal floating piston
- Nitrogen gas charge
- Multi-stage disc valving
- 2.0-inch body for oil capacity and heat dissipation
- 14mm chrome hardened shaft
- Polyurethane shock boot included
- Silver powder coat finish
- Vehicle specific valving for each application
Choosing a shock for your lift
Shock length and travel should match the suspension you actually run. Stock and lightly lifted trucks use less extension than heavily lifted ones, so a shock suited to a 0 to 2 inch range may bind or overextend beyond it. Check ride height at each corner and compare the installed length against the shock’s extended and collapsed dimensions before buying.
Gas-charged monotube designs keep oil and gas separated so damping holds up under repeated hits. Good damping on the trail depends on the bushings and mounts too. Inspect the eyes and bushings on the old shock for wear, and replace any cracked or collapsed bushing before fitting the new shock so it sits square. Replace shocks in matching pairs on each axle so both sides react the same way over bumps.
- Measure installed length before ordering
- Inspect mount bushings during replacement
- Replace in pairs on the same axle
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2045 |
| Shock series | PRO-M |
| Position | Rear |
| Shock type | Monotube |
| Extended length | 24.8 in |
| Collapsed length | 15.9 in |
| Travel length | 8.87 in |
| Body diameter | 2.0 in |
| Upper mount | Loop |
| Lower mount | Loop |
| Shaft | 14mm chrome hardened |
| Gas charge | Nitrogen |
| Finish | Silver powder coat |
| Lift range | 0 to 2 in |
| Boot | Polyurethane, included |
Vehicle fitment
It fits the 2004–2015 Nissan Titan, including LE, PRO-4X, S, SE, SL, SV and XE versions.
Other Nissan trucks are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The shock is made for 0 to 2 inches of lift, so check your lift height against that range before ordering.
What’s included
One shock with a polyurethane boot.








