Overview
The Pro Comp Suspension 57013BX-2 is a 2.5-inch rear monotube shock built for vehicles with a 2.5 inch lift. It fits the 2003 to 2024 Toyota 4Runner and the 2007 to 2014 Toyota FJ Cruiser.
Pro Comp’s PRO-VST design uses a hard-anodized, thick wall impact forged body. The 17-4 PH stainless steel shaft is chrome plated, and the valving is tuned for each vehicle the shock is sold for.
Key features
- Rear monotube shock for a 2.5 inch lifted application
- Hard-anodized, impact forged body
- 17-4 PH stainless steel shaft, chrome plated
- Vehicle specific tuning
Lift height and rear shock setup
A shock designed for a specific lift height keeps its extension and compression range where the suspension expects it. When a truck is lifted, the rear axle sits at a different point in its travel, so the shock works at new angles. Matching the shock to the lift keeps the geometry closer to design and lowers the chance of bottoming out on the trail.
Anyone running a lift should also check the brake lines, driveshaft angles and sway bar links, since these parts move with the axle. Off-road use adds load through the shock mounts, so inspect the bolts and bushings after each rough trip and tighten or replace them as needed.
- Check brake line length after the lift
- Inspect sway bar links for wear
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 57013BX-2 |
| Shock series | PRO-VST |
| Position | Rear |
| Shock type | Monotube |
| Body diameter | 2.5 in |
| Lift height | 2.5 in lift |
| Charge | Gas charged |
Vehicle fitment
It fits the 2003 to 2024 Toyota 4Runner, in several trims, and the 2007 to 2014 Toyota FJ Cruiser.
Verify the year, model and trim against your truck before buying, particularly if it is a Tundra or Tacoma.
Installation notes
Confirm the vehicle has a 2.5 inch lift before ordering, since the valving is set for that height. Measure the shock being replaced and compare installed length, because a different length changes rear ride height. Check the rear mounts for bolt size and bushing fit, and make sure the shock has travel clearance at full compression.
Make sure the mounts are tight and the shock clears the axle through full travel before off-road use. Check the shock body after the first trip for oil seepage or boot damage.
What’s included
One rear monotube shock under part number 57013BX-2.

















