Overview
The Pro Comp Suspension PR2017 is a PRO-M front monotube shock for the 2006 to 2008 Dodge Ram 1500. It is designed for trucks with 0 to 2 inches of lift and is sold individually.
The shock is nitrogen gas charged, with a floating piston that separates oil and gas. Pro Comp describes its shock body as having extra oil capacity, and the valving is vehicle specific.
Key features
- Front monotube design for 0 to 2 inches of lift
- Extended length 21.2 inches, collapsed length 15.1 inches
- Nitrogen gas charged with floating piston
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Hardware and bushing checks
The upper stem and lower loop are the wear points most often overlooked when a front shock is swapped. Rubber bushings that have hardened can let the shock rattle or wander under braking, and worn mounting hardware may shift the damper’s angle over time. Inspect both ends before installing the new unit, and replace any bushing that cracks or feels loose in its bore.
Front shocks on half-ton pickups work hardest on washboard roads and during quick steering inputs, so the body and seals take a steady beating. Keep the boot clean and free of grit, because abrasive debris can score the chrome shaft and shorten seal life. After the first few highway miles, look for oil film along the shaft and check that the damper does not bind near full travel.
- Clean the shaft before fitting
- Check spring seats for corrosion
- Torque mounts after the first drive
- Recheck steering clearance after installation
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2017 |
| Shock series | PRO-M |
| Position | Front |
| Extended length | 21.2 in |
| Collapsed length | 15.1 in |
| Upper mount | Stem |
| Lower mount | Loop |
| Lift | 0 to 2 in |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2006 to 2008 Dodge Ram 1500 in Laramie, SLT, ST, SXT, Sport and TRX4 trims.
Check the year, model and trim against your own truck before buying, especially with Ram 2500 or 3500 trucks in mind.
Installation notes
The 21.2 inch extended and 15.1 inch collapsed lengths are the figures to match against the front shock being removed. Because this shock is for 0 to 2 inches of lift, a truck that has been lifted further will need a different length. The stem top must seat properly in the factory upper mount, and the 2 inch body should be checked for clearance against the front spring and the inner fender.
The front mounts on this Dodge Ram 1500 should be measured before fitting, because a stem top upper mount must seat fully in the factory bracket. Confirm the loop lower mount sits square at the axle, and inspect the boot after the first drive on rough ground.
Confirm the front shock body clears the brake hose and the front spring at full steering lock on both sides.
The silver powder coat finish is listed in the specifications for this single shock.
What’s included
One PRO-M front monotube shock with polyurethane boot under part number EXPPR2017.









