Overview
The Pro Comp PRO-X Twin Tube Shock Absorber 925510B (part number EXP925510B) is a gas-charged twin tube shock with a 25.8 inch extended length and a 15 inch collapsed length. It fits the 1978–1979 Ford Bronco in the Custom, Northland and Ranger XLT trims and is sold individually.
The PRO-X series suits vehicles that see a lot of paved roads with the occasional off-road trip. It uses a general-purpose twin tube design with 10 stage velocity sensitive valving, a 5/8 inch chrome hardened piston rod and a Teflon rebound stop. Extended lengths accommodate lifted trucks.
Key features
- Twin tube design, nitrogen stabilized
- 10 stage velocity sensitive valving
- 1-3/8″ nylon banded piston
- 5/8″ chrome hardened shaft with Teflon rebound stop
- Stem upper mount and loop lower mount
- Black powder coat finish
- Sold individually; optional shock boot sold separately
Bronco ride height and care
A shock controls wheel movement after each bump, so its job grows when a Bronco carries larger tires or a lift. Twin tube designs use a single working cylinder inside an outer tube, and the 10 stage valving tunes how fast the shock resists motion at different speeds. A steady, controlled rebound keeps the tires on the ground.
Older Bronco suspensions often have worn bushings and tired mounts, so inspect those first. Shocks are usually replaced in pairs on an axle for balanced handling. After installation, retighten the fasteners after a short drive and check the alignment, since ride height changes steering geometry.
- Check the mounts for cracks or rust
- Inspect bushings for splits
- Retighten fasteners after the first drive
- Replace shocks on an axle as a pair
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXP925510B |
| Product type | Twin tube shock absorber (PRO-X series) |
| Extended length | 25.8 inches |
| Collapsed length | 15 inches |
| Travel length | 10.78 inches |
| Body diameter | 2.0 inches |
| Upper mount | Stem |
| Lower mount | Loop |
| Finish | Black powder coat |
| Gas or hydraulic | Gas charged |
| Piston | 1-3/8″ nylon banded |
| Shaft | 5/8″ chrome hardened |
| Quantity | Sold individually |
Vehicle fitment
It fits the 1978–1979 Ford Bronco in the Custom, Northland and Ranger XLT trims. The universal location means the mounts on your truck decide placement.
Other Bronco model years and other Ford trucks are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Tighten all fasteners to the torque values for your vehicle. Support the vehicle on jack stands or a lift on level ground, never on a jack alone, and re-check fastener tightness after the first miles of driving.
Suspension work changes ride height, steering geometry and brake line and driveline clearances, so professional installation is recommended, and a wheel alignment is advised afterward. Check your local regulations on vehicle lift height and equipment.
Shocks are replaced in pairs on an axle for balanced handling, so plan for at least two. An optional shock boot is sold separately.
What’s included
One shock absorber.
Not included: a shock boot (optional, sold separately), and additional shocks for the other positions.









