Overview
The Pro Comp Suspension EXPPR2042 is a PRO-M monotube shock for the 2009 to 2014 Ford F-150. It has an extended length of 32.5 inches and a collapsed length of 20.1 inches, and it is sold individually.
The floating piston keeps the oil separate from the nitrogen gas, and the multi-stage disc pack is designed for ride and handling. The shock body is larger than standard for more oil capacity and better heat dissipation.
Key features
- Nitrogen gas charged monotube
- Floating piston to separate oil and gas
- Multi-stage disc pack valving
- 14 mm chrome hardened shaft
- Polyurethane shock boot included
Rear shock upkeep
A rear shock on an F-150 handles loads from the bed and the trailer hitch, and its loop mounts take side forces as the axle moves. Floating piston monotube design keeps the damping steady under heat, which matters on long grades or after repeated bumps. Check the rear ride height after loading the truck, because the shock’s travel is affected by the weight it carries.
Inspect the loop mounts at each oil change, looking for cracked rubber, loose fasteners and metal wear. Keep the polyurethane boot clean and intact, and wash mud from the shaft after trail use. If the truck starts to sag or bounce after a bump, the shock may be worn and should be checked before the next trip.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPPR2042 |
| Shock series | PRO-M |
| Position | Rear |
| Extended length | 32.5 in |
| Collapsed length | 20.1 in |
| Mounts | Loop, upper and lower (per the product specs) |
| Shaft | 14 mm chrome hardened |
| Finish | Silver powder coat |
Vehicle fitment
It fits the 2009 to 2014 Ford F-150, in several trims including XL, XLT, Lariat, King Ranch, Platinum and Limited.
Fit is limited to the 2009 to 2014 F-150 models named above. Confirm your truck’s year, model and trim before ordering.
Installation notes
Use the 20.1 inch collapsed and 32.5 inch extended figures when comparing this rear shock with the one being removed, since a difference in length changes the rear ride height. Confirm the lift on your F-150 before ordering. Inspect the loop mounts for fit and make sure the boot is intact before installation, because a damaged boot lets grit reach the shaft.
Check the loop mounts for fit and confirm the shock clears the frame, the spring and the fuel tank straps at full compression. A rear shock on a truck with a 4 inch lift should be checked for correct length, and the boot should seat fully on the shaft before the first drive.
Confirm the rear travel is clear of the fuel tank straps and the frame crossmember when the suspension is loaded, since a loop mount needs room to move freely.
What’s included
One PRO-M monotube shock with polyurethane boot under part number EXPPR2042.









