Overview
The Pro Comp ES9000 Series shock absorber, part number 918506, uses factory upper and lower mounts. It measures 18.59 inch extended and 11.78 inch collapsed, giving 6.81 inch of travel. Measure the shock being replaced before buying.
The ES9000 is a gas-charged twin-tube design with 10-stage velocity-sensitive valving. It has a 1 3/8 inch nylon-banded full-displacement piston head and double-welded mounts for strength and durability. It is designed for heavy loads as well as demanding driving.
Key features
- Twin-tube, gas-charged design.
- 10-stage velocity-sensitive valving.
- A 1 3/8 inch nylon-banded piston head.
- Double-welded shock mounts.
- Factory upper and lower mounts.
Gas-charged shocks explained
A gas-charged shock holds pressurized gas in the body, which helps prevent the damping fluid from foaming when the shock works hard. That consistency matters on rough roads and during repeated bumps, because a shock that foams can lose resistance quickly. Gas-charged units are commonly used on trucks that see both highway and off-road use. Shocks like this one are typically replaced in pairs at the same axle.
Because the gas is sealed, a failed shock usually shows as oil on the body or a shaft that moves too freely. Gas pressure can also be lost over time, which makes the ride feel soft and bouncy. Handle a gas-charged shock with care, keep it upright during storage, and do not heat the body with a torch. Replace it as a unit rather than attempting a field repair.
- Check for oil on the body
- Compare rebound by hand
- Store upright and keep the shaft clean
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 918506 |
| UPC | 614901070736 |
| Shock series | ES9000 |
| Extended length | 18.59 inch |
| Collapsed length | 11.78 inch |
| Travel length | 6.81 inch |
| Upper mount | Factory |
| Lower mount | Factory |
| Adjustable | No |
| Remote reservoir | No |
| Finish | White |
| Dust boot included | No |
| Sold as | Each |
Vehicle fitment
Fit must be matched to the truck’s year, model and trim. Compare both the extended and collapsed lengths with the shock being replaced.
Because the lengths differ by less than a tenth of an inch from the 918504, measure the original shock rather than relying on the part number alone. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Measure the factory mounts at full extension and compression, since the lengths are the main fit check for a truck without a listed fitment.
What’s included
One ES9000 shock absorber.
Not included: a dust boot.








