Overview
The Pro Comp PXA5161-297050 is a 20×9 aluminum split-spoke wheel from the Pro Comp 61 Series, in satin black milled with an 8 on 170 bolt pattern. It is one wheel, sold without lug nuts or a center cap, and its 125 center bore is the figure to match first.
The 61 Series is low-pressure cast and rated from 2500 to 3650 lbs per wheel. This wheel is 9 inches wide with a zero offset and a backspacing of 5. An eight-lug layout mounts only to a hub that uses 8 on 170 hardware.
Key features
- Low-pressure cast aluminum
- Split-spoke design
- 20-inch diameter and 9-inch width
- 8 on 170 bolt pattern
- Center bore of 125
- Zero offset with 5 backspacing
Hub-centric fit basics
An 8 on 170 wheel relies on the lug holes and the center bore working together. The lugs clamp the wheel, while the hub pilot centers it, so a correct bolt pattern alone does not guarantee a good fit. Verify the pilot diameter and the hub face before tightening anything.
Heavier trucks and SUVs with this layout carry more load, so the rim, tire and lug seats all see more force. Inspect the wheel periodically, watch for uneven tire wear that can signal a wheel out of true, and keep the lug nut seats clean. Replace studs or nuts that show thread damage.
- Measure the hub pilot before mounting
- Clean the hub face and rotor contact surface
- Use lug nuts that match the seat type
- Recheck torque after the first trail runs
Specifications
| Brand | Pro Comp Alloy Wheels |
|---|---|
| Part number | PXA5161-297050 |
| Series | 61 Series |
| Style | Split spoke |
| Construction | Aluminum |
| Finish | Satin black milled |
| Diameter | 20 inches |
| Width | 9 inches |
| Bolt pattern | 8 on 170 |
| Center bore | 125 |
| Offset | 0 |
| Backspacing | 5 |
| Load rating | 2500 to 3650 lbs per wheel (Pro Comp alloy range) |
Vehicle fitment
This wheel is not tied to one vehicle model. An 8 on 170 hub with a 125 center bore is required, and the vehicle’s year, model and trim decide whether that hub is present.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Eight lug holes at 170 must line up with the hub exactly. Test-fit the 20-inch rim with the tire on the vehicle to confirm clearance at the caliper and steering components. Check the hub pilot diameter against the 125 center bore, because the wheel only centers on a hub that fits that bore.
What’s included
One 20×9 aluminum wheel. Have the lug nuts and center cap your hub requires ready before mounting.











