Overview
The Poison Spyder 11-04-010-ALUM is a set of stock crusher corners in bare aluminum for the 1976–1986 Jeep CJ7, in Base, Golden Eagle, Golden Hawk, Laredo, Limited and Renegade trims. Crusher corners are rear corner armor that protects the body corners from side and corner impacts on the trail.
The stock corners keep the factory wheel opening and fuel filler opening, and they include mounting holes for all of the factory equipment, including the factory flares, tail light and license plate frame.
The corners are made from high strength, lightweight 3/16-inch 6061-T6 aluminum. The aluminum version weighs up to 50 pounds less than the steel corners and still guards against side and corner impacts. They are CNC laser cut and formed for a precise fit, the same as the steel version.
Aluminum crusher corners can be painted, powder coated, polished or left as raw aluminum. Poison Spyder says there is no risk of corrosion other than light surface oxidation over time.
Key features
- Bare aluminum finish, ready for paint, powder coat or raw
- 3/16-inch 6061-T6 aluminum plate, CNC laser cut
- Factory wheel opening and fuel filler opening
- Mounting holes for factory flares, tail light and license plate frame
- Up to 50 pounds lighter than steel corners
- Stainless steel hardware
Finishing aluminum corners
Bare aluminum can be left natural for a raw look or finished to match the rest of the Jeep. Aluminum takes paint and powder coat well when the surface is clean and lightly scuffed. Remove any shop oil or fingerprints with a degreaser before priming, since contamination is a common reason coatings lift early.
Aluminum left raw will dull with time and gather light surface oxidation. A soft abrasive pad and mild cleaner restore the look, and a clear coat can slow the change. Keep the stainless hardware and the aluminum surface separate from bare steel parts where possible, which helps reduce corrosion at contact points.
- Scuff the surface before priming
- Use a clear coat on raw aluminum to slow dulling
- Inspect the corner edges after rough trail use
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 11-04-010-ALUM |
| UPC | 614901723182 |
| Corner type | Full |
| Material | 3/16-inch 6061-T6 aluminum plate |
| Cutouts | Square cut outs |
| Hardware | Stainless steel |
| Finish | Bare aluminum |
| Installation type | Cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
Poison Spyder lists these stock crusher corners as a direct fit for the 1976–1986 Jeep CJ7, including the Base, Golden Eagle, Golden Hawk, Laredo, Limited and Renegade models.
The CJ5, Scrambler and Wrangler models are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Installation requires cutting or drilling. The corners keep the factory fuel filler and wheel openings, so the existing mounts are reused. Check the factory flares and tail light fit before drilling.
What’s included
A set of bare aluminum stock crusher corners with stainless steel hardware and the square cutouts described above.
Not included: paint or powder coating, and any aluminum flares or tail light.












