Overview
The Poison Spyder 14-05-070 is a rear DeFender flare, 3 inch wide, finished in bare steel. It is designed to match Poison Spyder’s front DeFenders and to be added to comp cut corners.
The flare can also be added to an existing set of Crusher Corners or to a competitor’s full corner armor. It is fabricated from 3/16 inch plate, and it has a sturdy outer edge with a full under-side return for strength.
The flare is a tubeless design, so it is not built on the thinner tubing that traditional tube fenders use. It is weld-on and set up with no cutting or drilling. Confirm the mounting method before fitting.
Key features
- 3 inch wide rear flare
- Bare steel finish
- Formed from 3/16 inch plate steel
- Full under-side return on the outer edge
- Designed for comp cut corners
- Matches Poison Spyder’s front DeFenders
Comparing flare mounting methods
Flare mounts vary between bolt-on and weld-on designs, and the method controls how the flare is removed and repaired. Weld-on flares are harder to remove but fasten strongly to the body. Before fitting, confirm the mounting method, check how the flare lines up with the existing corner or comp cut, and mark the placement.
Tube and tubeless flares differ in how the outer edge is built, and the outer rail takes most of the rock impact. Inspect the edge and mounting points after trail use. Bare steel should be coated or touched up to slow rust, especially where it meets the body.
- Confirm weld-on or bolt-on before fitting
- Mark placement before any welding
- Inspect the outer edge after trail use
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 14-05-070 |
| UPC | 614901725445 |
| Position | Rear |
| Flare width | 3 inch |
| Material | 3/16 inch plate steel |
| Finish | Bare steel |
| Type | Tube flare |
| Installation | No cutting or drilling required |
Vehicle fitment
The flare fits the 1976–1983 Jeep CJ5, the 1976–1986 Jeep CJ7, the 1981–1985 Jeep Scrambler, the 2004–2006 Jeep Wrangler LJ, the 1997–2006 Jeep Wrangler TJ, and the 1987–1995 Jeep Wrangler YJ, across the trim lines for each model.
The list covers several generations, so confirm your vehicle’s year, model and trim before ordering.
Installation notes
The mounting is weld-on, and it is set up with no cutting or drilling. Confirm the mounting method before fitting.
What’s included
One rear DeFender flare in bare steel.









