Overview
The Poison Spyder 18-18-030 is a C-pillar kit for the 2007–2016 Jeep Wrangler Unlimited (JK) four-door. It adds strength to the rear passenger portion of the factory cage and is intended to be used with Poison Spyder’s JK 4-door trail cage installation.
The kit is made from CNC laser cut lengths of 1.75-inch OD, .120 wall DOM tubing, along with engineered foot plates. The foot plates are fabricated from CNC laser cut, brake-formed 3/16-inch plate steel. Indexing tabs and slots are built into the joint where the DOM tube meets the foot plate, which Poison Spyder says makes assembly quick and easy. The kit must be welded to the OE cage at the top and bolts in at the lower end.
Key features
- Adds strength to the rear passenger side of the OE cage
- 1.75-inch OD, .120 wall DOM tubing
- Foot plates CNC laser cut and brake-formed from 3/16-inch plate
- Indexing tabs and slots for quick assembly at the foot plate
- Welded at the top, bolts in at the bottom
Fitting the top weld
The top weld is the critical joint on a C-pillar kit, because it ties the new tube into the factory cage. A clean, full bead gives the kit a solid base, while a poor weld can crack under a twist or rear-end impact. Prepare the weld area by grinding away paint and rust, and fit the kit before starting the final beads so the angle is right.
The lower end bolts in and the foot plate sits against the body, so keep bolts snug without overtightening the plate. After installation, check the top weld, the foot plate and the tube for cracks or movement after rough trails. Replace worn hardware and repair any fresh cracking before the next run. Keep the joints clean and dry to slow corrosion.
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 18-18-030 |
| UPC | 614901727739 |
| Tubing | 1.75-inch OD, .120 wall DOM steel |
| Foot plates | 3/16-inch plate steel |
| Installation type | Weld in at top, bolt at bottom |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2007 to 2016 Jeep Wrangler (JK) Unlimited, including the Unlimited Rubicon, Sahara, Sport, Sport S, X, 70th Anniversary and 75th Anniversary models.
It is made for the four-door JK. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The top of the kit must be welded to the OE cage, so this is not a bolt-on part. The lower end bolts to the Jeep. Weld quality matters on roll bar components, so have an experienced welder do the top welds.
What’s included
The kit includes the DOM tubing lengths and the engineered foot plates.
Not included: the factory cage it attaches to, which must already be installed on the Jeep, and the trail cage kit it is designed to complement.














