Overview
The Poison Spyder BFH front bumper 11-16-020-DB is a bare steel stubby front bumper with shackle tabs and a Brawler Bar, built from 3/16 in plate steel with an integrated winch mount. Poison Spyder Customs designed it for hardcore four-wheelers who value strength, simplicity and function.
BFH stands for Built For the Hammers. The bumper is CNC laser-cut from a single piece of high strength plate, then brake-formed, and is no wider than the Jeep’s frame rails with angled facets to help it slide over rocks. The Brawler Bar extends 7.4 in forward and is 9.8 in high from the top surface of the bumper.
Key features
- Bare steel finish
- CNC laser-cut from a single piece of 3/16 in high strength plate steel, precision brake-formed
- Integrated winch mount
- Brawler Bar, a lower-profile Stinger, extends 7.4 in forward
- Brawler Bar stands 9.8 in high from the top of the bumper
- Recovery shackle tabs machined from 1 in thick plate steel for 3/4 in shackles
- Tabs matched to the bumper angles for zero loss in approach angle
- D-ring mount included
- Stubby width, no wider than the frame rails
Recovery and winch planning
A front bumper with shackle tabs and a winch mount is built to take recovery loads, so plan the rest of the recovery setup as a system. Choose shackles and recovery straps that match the tab size and the rated load of your winch. Use a fairlead and keep the winch cable and line in good condition, since frayed cable is a common cause of failure.
A stinger-style bar protects the front of the vehicle but changes the approach and winch angle, so check the line of pull before setting up a recovery. Inspect the welds and tabs after hard use, and check that the D-ring or shackle hardware is free of bends.
- Match shackles to tab size
- Inspect welds after hard use
- Check winch wiring and fusing
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| UPC | 614901723557 |
| Product type | Front bumper with winch mount |
| Finish | Bare steel |
| Material | 3/16 in plate steel |
| Width | Stubby |
| Winch mount | Included (integrated) |
| D-ring mount | Included |
| Light mounts | Not included |
| Brawler Bar projection | 7.4 in forward |
| Brawler Bar height | 9.8 in from the top surface |
| Shackle tab thickness | 1 in plate steel |
| Shackle size | 3/4 in |
| Fit type | Direct fit |
| Part number (title) | 11-16-020-DB |
Vehicle fitment
This bumper is a direct fit type and is no wider than the frame rails. Confirm your Jeep’s model, year and chassis before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A bumper is a heavy structural part, so use a helper or a lift to position it. Bare steel will rust unless coated, so paint or powder coat it. If you add a winch, wire it with correct fusing and follow its instructions. Offer the bumper up to the frame to confirm that the bolt holes and shackle tabs line up before final tightening, and then check the headlights and any bumper-mounted accessories for clearance.
What’s included
- Front bumper with integrated winch mount
- Brawler Bar
- Recovery shackle tabs
- D-ring mounts
Not included: Light mounts, a winch and shackles (the finish is bare steel).














