Overview
The Poison Spyder Brawler Lite with Trail Stinger is a front bumper for the Jeep Wrangler JK (2007-2018), in bare 3/16″ plate steel with recovery shackle tabs. It is a grille-width, high clearance bumper for both 2-door and 4-door models.
The Trail Stinger is modeled on the Trail Stinger Poison Spyder developed years ago, offering clean lines and a measure of forward-flop protection. It is made of 1-3/4″ diameter .120 wall DOM tubing and is fortified by a pair of 1-1/4″ diameter .120 wall DOM tube gussets. The bumper can be mounted without cutting or altering the frame rails, and it has recessed buckets for the factory fog lamps.
Key features
- Grille-width, high clearance bumper from 3/16″ plate steel
- Trail Stinger from 1-3/4″ diameter .120 wall DOM tubing
- Two 1-1/4″ diameter .120 wall DOM tube gussets
- Mounts without cutting or altering the frame rails
- Recessed buckets for the factory fog lamps
- Factory crash bar can stay or be removed
- Shackle tabs CNC machined from 1″ thick steel billet for 3/4″ recovery shackles
Frame and winch considerations
A front bumper carries a lot of load during recovery, so the mounting points matter as much as the plate and tubing. Winch loads travel through the bumper and into the frame, so make sure the winch is secured to the bumper at the rated points and that the mounting bolts are torqued correctly. Check the winch’s bolt pattern against the bumper before buying, and plan wiring with the battery and fuse in mind.
Shackle tabs are only as good as the bumper they are welded to. Inspect the welds after trail use, look for cracks around the tab base, and keep the recovery points clear of mud so they are easy to check. Bare steel can rust in wet climates, so touch up any bare spots with a rust inhibitor.
- Confirm the winch bolt pattern before ordering
- Check tab welds after rough recoveries
- Keep recovery points clean and visible
- Re-torque bumper bolts after the first outings
Specifications
| Brand | Poison Spyder |
|---|---|
| UPC | 614901727234 |
| Type | Brawler Lite front bumper with Trail Stinger and shackle tabs |
| Material | 3/16″ plate steel |
| Finish | Bare steel |
| Stinger tubing | 1-3/4″ diameter, .120 wall DOM |
| Gussets | Two 1-1/4″ diameter, .120 wall DOM tubes |
| Shackle tab stock | 1″ thick steel billet, for 3/4″ shackles |
| Body styles | 2-door and 4-door |
Vehicle fitment
This Brawler Lite is built for the Jeep Wrangler JK from 2007 to 2018, in 2-door and 4-door models.
It is built for the JK and does not cover the TJ, LJ or JL generations. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Warn PowerPlant winches are not a direct fit with the DOM tube gussets, and Poison Spyder says they can be installed with minor modification by the installer. If you keep the factory Crash Bar, Poison Spyder suggests the Brawler Lite Skid Plate, which is available separately and covers the bar and the electronic sway bar disconnect.
What’s included
- Front bumper with Trail Stinger
- Pair of recovery shackle tabs welded to the bumper
Not included: a winch, fairlead and the optional Brawler Lite Skid Plate.














