Overview
The Moog ES800515 is a driver side outer tie rod end for 2007–2018 Ford Expedition and Lincoln Navigator SUVs and the 2009–2018 Ford F-150. It is sold individually.
When the steering wheel turns, Moog explains, the motion goes through the steering rack, then the tie rods, then the steering arm or spindle. The tie rod ends are also tied closely to alignment. Moog designs its tie rod ends as forged one-piece units, which it says last longer than the two-piece original designs it finds on many vehicles, and adds a neoprene-sealed rubber boot with a small flushing valve and hardened full-ball metal studs.
Moog stresses that tie rods are crucial to the steering system, because without them the vehicle cannot be turned. The design used here, a one-piece forged body with a boot that resists extreme heat and abrasion, is intended to hold up better than the original construction. This part is sold individually, so it covers only the driver side outer position.
Key features
- Driver side outer tie rod end
- Sold individually
- Forged one-piece unit
- Neoprene-sealed rubber dust boot
- Boot resists extreme temperatures and abrasion
- Hardened full-ball metal studs
Spotting tie rod wear
Outer tie rod ends wear at the ball joint, and the first sign is usually play at the front wheel. With the front of the truck raised safely, rock the wheel top to bottom and side to side; movement at the joint means the end needs attention. A cracked or split dust boot lets water and grit in, which shortens the life of the joint even when the stud still looks sound.
Uneven or feathered tire wear across the tread often points to alignment changes caused by a worn tie rod end. Because the outer end sets toe, replacing it usually calls for an alignment afterward. When the steering wheel pulls or sits off-center on a straight road, inspect the tie rod ends, the steering arm and the inner joints before blaming the tires.
- Rock each front wheel to check for play
- Look for torn boots and dried grease
- Check tire wear patterns for alignment changes
Specifications
| Brand | Moog |
|---|---|
| Part number | ES800515 |
| Product | Outer tie rod end |
| Side | Driver side |
| Quantity | Sold individually |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber |
| Studs | Hardened full-ball metal |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2007–2018 Ford Expedition, the 2007–2017 Ford Expedition EL, the 2018 Ford Expedition Max, the 2009–2018 Ford F-150 including Raptor and SVT Raptor, the 2007–2018 Lincoln Navigator and the 2007–2018 Navigator L.
The part is for the driver side, and the F-150 listing begins in 2009, so earlier F-150s and passenger side tie rod ends are not covered. The Expedition EL is listed through 2017 and the Expedition Max for 2018. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Moog recommends an alignment immediately after any tie rod replacement. This is one driver side part, so a passenger side tie rod end is a separate item. The boot has a small valve so old grease and contaminants can be flushed out.









