Overview
The Moog EV370 is a front inner tie rod end for rack-and-pinion steering on 1999–2007 Chevrolet Silverado 1500 and GMC Sierra 1500 pickups, including the 2007 Classic models and the Silverado 1500 HD. It fits either the left or right side, so one part number covers both ends of the rack.
Steering motion travels from the wheel through the steering rack, then through the tie rods, and finally to the steering arm or spindle. Without working tie rods the vehicle cannot be turned, and tie rods have a direct effect on alignment. The EV370 is a forged one-piece unit, whereas many original tie rods are two-piece assemblies, and the one-piece design is intended to lower the chance of early wear.
Moog fits the EV370 with hardened full-ball metal studs, which it says can stand up to much more than the original equipment. The boot includes a small valve so old grease and contaminants can be flushed out, which helps keep the joint serviceable.
Key features
- For rack steering only
- Fits the left or right side
- Forged one-piece unit rather than a two-piece assembly
- Neoprene-sealed rubber dust boot
- Boot resists extreme temperatures and abrasion
- Small valve in the boot lets old grease and contaminants be flushed out
- Hardened full-ball metal studs
Alignment after a tie rod change
Tie rods set the toe angle of the front wheels, so replacing an inner tie rod changes alignment even when the new part is installed correctly. Wheel alignment should be checked after the work is finished. Uneven tire wear, a pulling steering wheel or a crooked center position are common signs that the setting has moved.
A rack-steering truck depends on the inner tie rod to move the steering rack, so any play in that joint can make the steering feel vague. Inspect the rack boots at the same time, since a torn boot lets dirt into the rack and the inner joint. Replacing a worn inner tie rod while the boots are off is a sensible time to check the rack.
Keep the grease valve in mind during service. The valve allows old grease and contaminants to be flushed out, which helps the joint stay serviceable between replacements. Wipe clean the area around the boot before adding fresh grease, so dirt is not pushed inside.
- Get an alignment after replacing a tie rod
- Check the rack boots while the tie rod is off
- Look for uneven tire wear as an early sign
Specifications
| Brand | Moog |
|---|---|
| Part number | EV370 |
| Product | Front inner tie rod end |
| Steering type | Rack steering only |
| Side | Left or right |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber |
| Studs | Hardened full-ball metal |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1999–2007 Chevrolet Silverado 1500, the 2007 Silverado 1500 Classic, the 2001–2003 and 2005–2006 Silverado 1500 HD, the 2007 Silverado 1500 HD Classic, the 1999–2007 GMC Sierra 1500 and the 2007 Sierra 1500 Classic.
It is for rack-steering trucks in the years above. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Moog advises getting an alignment done immediately after replacing tie rods. The grease valve in the dust boot is there so that old grease can be flushed out during service.










