Overview
The Moog ES80761 is a front outer tie rod end for the 2004–2007 Chevrolet Colorado and GMC Canyon, and for the 2006 Isuzu i-280 and i-350. It fits the left or right side, and it is the first version of this tie rod end, used through VIN 68272519.
Later trucks use ES800643 instead, so the VIN decides which of the two parts is needed. The ES80761 is a forged one-piece unit protected by a neoprene-sealed rubber dust boot. The one-piece design resists early wear better than many two-piece original parts, and the boot is built to resist temperature extremes and abrasion.
Check the VIN before ordering. Trucks built through VIN 68272519 use this first-version part, and later models need ES800643. The same rule applies to the Isuzu i-280 and i-350, so a VIN check is worthwhile on every vehicle.
Key features
- Front outer tie rod end
- Fits left or right side
- For models with the first version of the tie rod end, through VIN 68272519
- Later models use ES800643
- Forged one-piece unit
- Neoprene-sealed rubber dust boot
Checking the VIN first
The VIN is the deciding factor for this tie rod end, so find it before any parts are ordered. The VIN plate sits at the driver side of the dash and is also on the door jamb label, and the number can be compared directly against the limit. Recording the VIN with the order prevents a return if the first version does not match the truck.
Front outer tie rod ends carry steering motion from the rack to the spindle, so wear shows up as wandering, loose steering or uneven front tire wear. Before replacing, check the inner joints and the rack boots as well. When both sides need work, replacing them together keeps the steering geometry balanced, and a shop with alignment equipment can set toe afterward.
Keep the old part until the new one is confirmed to match in length and stud shape, and note the VIN on the job card for the next service visit.
- Compare the VIN against the limit before ordering
- Check each side separately
- Record the VIN with the service record
Specifications
| Brand | Moog |
|---|---|
| Part number | ES80761 |
| Product | Front outer tie rod end |
| Side | Left or right |
| Applies through VIN | 68272519 |
| Later-model part | ES800643 |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2004–2007 Chevrolet Colorado and 2004–2007 GMC Canyon, and the 2006 Isuzu i-280 and i-350, for vehicles with the first-version tie rod end through VIN 68272519.
Trucks built after VIN 68272519 take ES800643, so the model year alone does not confirm this part. The Isuzu i-280 and i-350 apply to 2006 only. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Moog recommends an alignment immediately after tie rod replacement. Check the VIN before ordering, since the later design is a different part. The VIN is found on the vehicle, so compare it against 68272519 before the old tie rod end comes off.










