Overview
The Moog ES3492T is a front outer tie rod end for rack steering on 1999–2007 Chevrolet Silverado 1500 and GMC Sierra 1500 trucks. It can be used on either the left or right side and is a forged one-piece unit.
Outer tie rod ends are the joint nearest the wheel, passing steering rack movement on to the steering arm or spindle. The ES3492T has a neoprene-sealed rubber dust boot that resists extreme temperatures and abrasion, and the boot includes a small valve for flushing old grease and contaminants. It uses hardened full-ball metal studs.
The outer end sits at the wheel side of the linkage, where the boot sees the harshest conditions. The neoprene seal and flushing valve are built for that exposure. Replacing this part is also a good time to check the matching inner end for wear.
Key features
- For rack steering only
- Fits left or right side
- Forged one-piece unit
- Neoprene-sealed rubber dust boot
- Boot valve for flushing old grease
- Hardened full-ball metal studs
Rack steering and wheel-side wear
The outer tie rod end takes the steering rack’s motion to the wheel, so it works through every turn and every rough patch of road. Wear usually starts at the stud or the boot, and a torn boot lets dust and water into the joint. Checking for stud play and boot condition during routine brake or tire work is an easy way to catch problems early.
Outer ends wear faster on trucks that tow, carry heavy loads or drive on gravel and washboard roads. Keeping the boot clean and avoiding harsh curb strikes helps extend service life. When one side is replaced, inspect the other side as well, and check that the wheel returns to center during a low-speed test drive.
Specifications
| Brand | Moog |
|---|---|
| Part number | ES3492T |
| Product | Front outer tie rod end |
| Steering type | Rack steering only |
| Side | Left or right |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber |
| Studs | Hardened full-ball metal |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 1999–2007 Chevrolet Silverado 1500, the 2007 Silverado 1500 Classic, the 2001–2003 and 2005–2006 Silverado 1500 HD and the 2007 Silverado 1500 HD Classic. On the GMC side it fits the 1999–2007 Sierra 1500 and the 2007 Sierra 1500 Classic.
Heavier 2500 and 3500 models are not covered, and the part is intended for rack steering only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
An alignment should follow any tie rod replacement, since tie rods play a key role in holding alignment. Fitting a new outer end is a good moment to look over the matching inner end and the dust boots for damage.










