Overview
The Moog EV800098 is a front inner tie rod, sold individually, for the 2006-2010 Dodge Ram 1500 and the 2011-2012 Ram 1500. It is a direct-fit steering part.
Tie rods carry steering motion from the steering rack to the steering arm or spindle, and they affect alignment. This tie rod is a forged one-piece unit rather than a two-piece assembly, which helps reduce early wear. It has a neoprene-sealed rubber dust boot with a small valve for flushing old grease, and hardened full-ball metal studs. Inspect the outer tie rod ends and boots at the same time as the inner tie rod, and replace parts based on the inspection results.
Key features
- Front inner tie rod
- Sold individually
- Direct fit
- Forged one-piece design.
- Hardened full-ball metal studs
- Fits the 2006-2010 Dodge Ram 1500 and 2011-2012 Ram 1500
Ram steering maintenance
On a Ram 1500 a worn inner tie rod often shows up as wandering on the highway, a steering wheel that is off center and uneven wear on the inside edge of the front tires. Because the inner end sits near the steering rack, a split boot lets dirt and road salt reach the joint, which speeds up wear. Checking the boot during routine service and listening for clunks over bumps are simple ways to catch the problem early.
Replacing the inner tie rod should be followed by a complete alignment, since toe and steering geometry change during the job. Inspecting the outer ends and the steering damper hardware at the same visit helps the whole linkage wear evenly. Keeping an eye on tire wear after the work is a practical way to confirm the repair is holding.
- Check the boot for grease leaks at each service
- Inspect the outer tie rod ends at the same time
- Get an alignment immediately after replacement
Specifications
| Brand | Moog |
|---|---|
| Part number | EV800098, also written MOGEV800098 |
| Product type | Inner tie rod |
| Position | Front, inner |
| Sold as | Individually |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2006-2010 Dodge Ram 1500 (Laramie, SLT, SRT-10, ST, SXT, Sport, TRX and TRX4) and the 2011-2012 Ram 1500 (Big Horn, Express, Laramie, Laramie Longhorn, Outdoorsman, SLT, ST, Sport, Tradesman and Tradesman HD).
It does not fit the Ram 1500 after 2012, or the Ram 2500 and 3500. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Steering parts are safety-critical, so professional installation is the safer choice. Support the vehicle securely on jack stands and tighten every fastener to the torque specification for your vehicle. Replace any cotter pins or locking hardware the job calls for. Get the wheel alignment checked right after the work, since steering and suspension changes affect toe and handling. Re-check fastener tightness after the first few miles, and test steering at low speed before returning to normal driving.
What’s included
One inner tie rod is included, sold individually. Check the package contents against your installation before starting.










