Overview
The Moog ES800558 is a passenger side inner tie rod end for Dodge and Ram heavy-duty pickups, fitting the 2003–2010 Ram 2500 and 3500, the 2008 Ram 1500 and the 2011–2013 Ram 2500 and 3500. It is the second design and mounts at the connecting tie rod on the passenger side, which is the front left position.
Moog says tie rods carry steering motion on to the steering arm or spindle and strongly influence alignment. Its tie rod ends are forged as one-piece units rather than the two-piece assemblies common on original parts, with a neoprene-sealed rubber dust boot that stands up to extreme temperatures and abrasion, and hardened full-ball metal studs that Moog says outlast original ones.
The Ram 2500 and 3500 listing spans two generations, the Dodge-badged trucks to 2010 and the Ram-badged trucks from 2011 to 2013. Moog labels this part the second design of its inner tie rod end, so the design version is worth confirming along with the model year.
Key features
- Inner tie rod end at the connecting tie rod
- Passenger side listing, also noted as front left
- Second design
- Forged one-piece unit
- Neoprene-sealed rubber dust boot
- Hardened full-ball metal studs
Choosing an inner tie rod end
An inner tie rod end connects the steering rack to the tie rod on the side where it is installed. It carries the side-to-side motion of the steering into the outer ends and helps set the wheel alignment, so wear at this joint shows up as a loose or wandering steering feel. When buying a replacement, match the side and design version to the truck, since each side uses its own inner end.
Inner ends are often replaced along with the outer ends when the steering has been worn for a long time, because old parts can load a new one. Check the rack boot as well, since a torn boot lets dirt into the joint and speeds up wear. After any replacement, have the alignment checked before driving the truck for long distances.
- Check the rack boot for tears when the inner end is replaced
- Inspect the outer tie rod ends at the same time
- Set the alignment after the new part is installed
Specifications
| Brand | Moog |
|---|---|
| Part number | ES800558 |
| Product | Inner tie rod end |
| Side | Passenger side at the connecting tie rod, noted as front left |
| Design version | Second design |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2008 Dodge Ram 1500, the 2003–2010 Dodge Ram 2500 and 3500, and the 2011–2013 Ram 2500 and 3500, including Power Wagon versions.
The Ram 1500 is listed only for 2008, and this is the second design, so other Ram 1500 years and the first-design part are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Moog says to align the vehicle right after replacing tie rods. Because the side is described two ways, confirm which position on your truck uses this inner tie rod end. The boot has a small valve so old grease and contaminants can be flushed out.










