Overview
The Moog DS1237 is a tie rod end for the 1991-1995 Jeep Wrangler YJ. It is a direct-fit steering replacement from Moog’s Problem Solver range, intended for owners restoring tight steering response on an older YJ.
Moog says its Problem Solver tie rods are designed for like-new steering, simple installation and longer life. The DS1237 adds a full ball metal stud that allows 360 degrees of rotation for steadier steering feedback.
Key features
- Full ball metal stud with 360 degrees of smooth, consistent rotation
- Powdered metal gusher bearing passes grease through to the stud
- Patent pending Sunoloy coated metal bearings for smooth stud swing
- Cover plate design with tighter tolerances than traditional covers.
- Direct-fit replacement for the YJ Wrangler
Restoring steering on an older Jeep
Tie rod ends on a Wrangler YJ take a lot of stress from trail use and rough pavement, so wear often shows up as wander, vague centering or a tire wearing on one edge. Replacing a worn end restores a tighter steering response, but the rest of the front end should be inspected at the same time.
Before buying, check the steering knuckle, drag link and track bar for wear, since a loose part elsewhere can make a new tie rod feel loose again. On an older YJ, the front end often carries aftermarket upgrades, so confirm that the new end suits your lift height and steering geometry.
- Inspect the drag link and track bar at the same time
- Keep the boot clean and free of cracks
- Plan a wheel alignment after any tie rod work
Specifications
| Brand | Moog |
|---|---|
| Part number | MOGDS1237 |
| Product line | Problem Solver |
| Part type | Tie rod end |
| Stud design | Full ball metal stud, 360 degrees of rotation |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1991-1995 Jeep Wrangler (YJ).
Earlier YJ years and the TJ, LJ and JK Wranglers are not covered. Verify fit for your year, model and trim before buying.
Installation notes
Replacing a tie rod end changes toe, so plan for a wheel alignment afterward.









