Overview
The Moog DS1419 is a right-hand inner tie rod end for the 1995-1997 Ford F-250. Moog sells it individually, so it covers one side of the steering linkage only.
It is part of the Moog Problem Solver line, which the company describes as engineered for like-new steering, easier installation and a longer life than the part it replaces.
Inner tie rod ends link the steering rack to the outer tie rod ends, which in turn move the steering knuckles. Replacing a worn inner end with the Moog DS1419 restores a tight joint on the right side of the truck.
Key features
- Right hand inner position, sold individually
- Full ball metal stud for 360 degrees of smooth rotational movement
- Powdered metal gusher bearing design for grease flow to the stud
- Sunoloy coated metal bearings, patent pending
- Patented cover plate design with tighter tolerances.
Inner ends and the steering rack
On an F-250 the inner tie rod end sits between the steering rack and the outer end, so its wear shows up as a loose or noisy steering feel at low speed. Each side has its own inner joint, so a worn one often means the opposite side is not far behind, even if it still feels acceptable.
Choosing a replacement starts with matching the side and thread direction to the existing part, then checking the rack boots for tears that would let dirt back into the new joint. Keep the boot clean and check it during oil changes or tire rotations, and plan on checking toe after any work.
- Match side and thread before buying
- Inspect rack boots for splits
- Check the outer end on the same side
Specifications
| Brand | Moog |
|---|---|
| Part number | MOGDS1419 |
| Product line | Problem Solver |
| Part type | Tie rod end |
| Position | Right hand inner |
| Quantity | Sold individually |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1995-1997 Ford F-250.
Only 1995-1997 F-250 is listed; earlier and later F-250 generations and other Ford trucks are not covered by this entry. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Inner tie rod ends set the steering linkage geometry, so have the toe setting checked after installation.









