Overview
The Moog EV800529 is a front inner tie rod end for the 2005–2019 Toyota Tacoma. It is a forged one-piece unit with a neoprene-sealed rubber dust boot and is a direct-fit replacement.
A tie rod passes steering force from the rack to the steering arm or spindle, and Moog points out that it is just as important to alignment as it is to steering. Moog says its tie rods differ from the original equipment in several ways. The most obvious is the single forged piece in place of the two-piece assembly common on factory parts, a design Moog says reduces early wear.
The tie rod passes steering force from the rack to the steering arm and affects alignment as much as steering response. A worn inner end is worth attention when steering feels loose. The EV800529 uses hardened full-ball metal studs built for more load than original parts, and its boot includes a small valve for flushing old grease and contaminants from the joint.
Key features
- Forged one-piece unit
- Neoprene-sealed rubber dust boot
- Boot resists extreme temperatures and abrasion
- Boot includes a small valve for flushing old grease and contaminants
- Hardened full-ball metal studs
- Direct fit for the Toyota Tacoma
Tie rod wear and alignment
The tie rod is one of the parts that decides whether a vehicle stays aligned, and it carries steering force between the rack and the steering arm. A worn inner end often shows up first as loose steering, a wandering feel on the highway or uneven front tire wear. Because the inner end sits close to the steering rack, its boot is easy to overlook, so look at it during every front end inspection.
A forged one-piece design avoids the joint between two pieces that can loosen on many factory assemblies. Pairing a new inner end with a sound outer tie rod end and a checked steering damper helps keep the front end tight. Plan an alignment after replacing any tie rod, since small changes in length move the toe setting.
- Loose or wandering steering
- Uneven front tire wear
- Torn or greasy inner boot
- Pulling to one side on a straight road
Specifications
| Brand | Moog |
|---|---|
| Part number | EV800529 |
| Product | Front inner tie rod end |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber |
| Studs | Hardened full-ball metal |
| Fitment type | Direct fit |
Vehicle fitment
It fits the Toyota Tacoma from 2005 through 2019, including Base, SR5, TRD Off-Road, TRD Pro, TRD Sport, Pre Runner, Limited and X-Runner versions.
It fits only the Tacoma from 2005 to 2019, so earlier Tacomas and other Toyota trucks are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Moog says to get an alignment done immediately after replacing tie rods. The inner end sits closer to the steering rack than the outer end, and its boot is the one with the flushing valve, so keep that in mind during service.










