Overview
The Moog ES80574 is a front outer tie rod end for 2006–2010 Dodge Ram 1500 pickups and the 2011–2012 Ram 1500. It fits on either the left or right side and is sold individually.
Tie rods carry steering rack motion to the steering arm or spindle, so the vehicle cannot be steered without them. This one is a forged one-piece unit, which replaces the two-piece assemblies used on many factory parts and reduces the chance of early wear. A neoprene-sealed rubber boot resists extreme temperatures and abrasion, and a small valve in the boot lets old grease and contaminants be pushed out. It has hardened full-ball metal studs.
Because this tie rod end fits the left or right side, one part number covers both outer positions on the Ram 1500, though the part is sold individually and each side needs its own.
Key features
- Front outer tie rod end
- Fits left or right side
- Sold individually
- Forged one-piece construction
- Heat- and abrasion-resistant neoprene-sealed boot
- Hardened full-ball metal studs
Choosing between tie rod styles
Steering geometry on a half-ton pickup changes with load, tire size and suspension height, and the tie rods are where that geometry is set. A lifted truck with larger tires puts more strain on the ends, so it is worth checking them more often. If you change wheel size or ride height, ask an alignment shop to confirm the setup before the truck returns to service.
When replacing one outer end, compare the old and new parts for length and thread count before installing, so the toe setting stays close. Inner tie rods, the center link and the idler arm should be inspected at the same time. A worn boot on the opposite side is a good reason to plan a second replacement soon. Keep notes on mileage and boot condition for future service.
On trucks used for towing, the loads on the steering linkage are higher than on daily drivers. Shorter inspection intervals for the boots suit that kind of use, and a quick check of steering play after long trips helps catch wear before it affects control.
- Compare length and threads before fitting
- Inspect the center link and inner ends
- Note the replacement mileage
Specifications
| Brand | Moog |
|---|---|
| Part number | ES80574 |
| Product | Front outer tie rod end |
| Side | Left or right |
| Quantity | Sold individually |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber |
| Studs | Hardened full-ball metal |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2006–2010 Dodge Ram 1500 in Laramie, SLT, SRT-10, ST, SXT, Sport, TRX and TRX4 versions, and the 2011–2012 Ram 1500 in Big Horn, Express, Laramie, Laramie Longhorn, Outdoorsman, SLT, ST, Sport, Tradesman and Tradesman HD versions.
Only the Ram 1500 is listed, for 2006 through 2012, so the heavier Ram 2500 and 3500 and other model years are not covered. The Ram 1500 listing names the Laramie, Big Horn, Express, Outdoorsman and Tradesman among its models. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Moog says to get an alignment done immediately after replacing tie rods. One part is one tie rod end, so a pair needs two, and the boot valve that allows old grease and contaminants to be flushed out is worth keeping in mind during later service.









