Overview
The Moog RK621293 is a front right lower control arm and ball joint assembly for the 2005–2015 Toyota Tacoma. Moog supplies the lower ball joint already installed in the control arm, so the assembly arrives as one unit for the right front lower position.
The assembly is built to close tolerances for straightforward installation and steering alignment. Its bushings are designed to resist wear, salt, road grime and oils, and the ball stud shape supports fatigue life and allows extra swing when needed.
Key features
- Pre-installed ball joint with a sealed socket
- Optimized bushings for quiet operation
- Ball stud shape for fatigue life and compensation for sag
- Heat treated to match or exceed OE requirements.
- Coated studs and e-coated cast iron and steel control arm
Replacing a worn lower arm
A lower control arm carries the wheel’s load and connects the hub to the frame, while the ball joint at its outer end lets the steering knuckle pivot. When that joint or the bushings wear, the front end can feel loose, wander on the highway, or knock over bumps. Replacing the arm as one assembly removes the old joint with it, so a worn joint is not pressed into a sound arm.
Because the lower arm sets part of the suspension geometry, it is worth checking the tie rod ends, the upper ball joints and the wheel bearings at the same time. Look for torn boots, grease leaks and play when the wheel is rocked at the top and bottom. Keeping both front sides in similar condition helps the truck track evenly.
- Inspect the outer boot for cracks before the old arm comes off
- Check the opposite side for matching wear
- Re-check the fasteners after the first few drives
Specifications
| Brand | Moog |
|---|---|
| Part number | RK621293 |
| Position | Front right, lower |
| Assembly | Control arm and ball joint |
| Control arm type | Box |
| Control arm material | E-coated cast iron and steel |
| Ball joint | Pre-installed, sealed socket |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2005–2015 Toyota Tacoma in Base, Pre Runner, TRD Pro and X-Runner trims.
The list does not include the 2016 and later Tacoma, the 4Runner or the Jeep and Dodge models covered by the upper assemblies in this line. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A new lower control arm and ball joint change the wheel alignment, so have the caster and camber checked after installation.
What’s included
The kit is one front right lower control arm and ball joint assembly.








