Overview
It is a front outer tie rod end that fits the left or right side. It fits the 2010–2020 Lexus GX460, the 2010–2020 Toyota 4Runner, the 2010–2014 Toyota FJ Cruiser and the 2016–2020 Toyota Tacoma as a direct-fit part.
Tie rods connect the steering system to the steering arm or spindle, so they are central to steering and wheel alignment. This one is a forged one-piece unit, unlike many two-piece original assemblies, which reduces early wear. A neoprene-sealed rubber dust boot resists extreme temperatures and abrasion, and a small valve lets old grease and contaminants be flushed out. Hardened full-ball metal studs complete the design.
Key features
- Front outer tie rod end, fits left or right side
- Forged one-piece unit.
- Neoprene-sealed rubber dust boot
- Boot has a small valve for flushing old grease and contaminants
- Hardened full-ball metal studs
- Direct fit for the listed Lexus and Toyota models
Inspecting the joint over time
The dust boot is the first part to fail on an outer tie rod end, and a torn boot lets grit into the ball joint quickly. Inspect the boot at every oil change, looking for cracks, splits, or grease thrown outward from the joint. Gravel roads, water crossings and high-pressure washing speed up boot damage, especially on the trucks and SUVs in this range.
Looseness in the stud is the sign that the part is finished. Grab the tire at the top and bottom and rock it, then grip the sides and push in and out; movement at the joint means it should be replaced. Clunks over rough pavement and a wandering wheel at highway speed point the same direction.
Outer tie rod ends are often replaced in pairs because both sides see the same miles. Keep the old part for comparison when fitting the new one, and recheck the steering after the first short drive.
- Inspect the boot at every oil change
- Check for play at the stud
- Replace in pairs when both sides show wear
Specifications
| Brand | Moog |
|---|---|
| Part number | ES80895 (MOGES80895) |
| Product type | Outer tie rod end |
| Position | Front, outer |
| Side | Fits left or right |
| Construction | Forged one-piece |
| Boot | Neoprene-sealed rubber dust boot |
| Studs | Hardened full-ball metal studs |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2010–2020 Lexus GX460 in Base, Luxury and Premium versions; the 2010–2020 Toyota 4Runner in Limited, Nightshade, SR5, SR5 Premium, TRD Off-Road, TRD Off-Road Premium, TRD Pro, Trail and Venture versions; the 2010–2014 Toyota FJ Cruiser in Base; and the 2016–2020 Toyota Tacoma in Limited, SR, SR5, TRD Off-Road, TRD Pro and TRD Sport versions.
Other Tacoma, Tundra or 4Runner years outside those ranges are not covered. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Steering parts are safety-critical, so professional installation is the safer choice. Support the vehicle securely on jack stands and tighten every fastener to the vehicle’s torque value. Replace any cotter pins or locking hardware the job calls for. Have the wheel alignment checked immediately afterward, since steering work changes toe. Re-check fastener tightness after the first few miles of driving.
What’s included
One outer tie rod end. Check the hardware needs against your installation before starting.










