Overview
The Moog ES3474 is an upper outer tie rod end for the passenger side of the 1999-2004 Jeep Grand Cherokee WJ. It is a forged one-piece unit with a neoprene-sealed rubber dust boot and hardened full-ball metal studs.
Moog explains that tie rods carry steering motion from the rack to the steering arm or spindle, and that they strongly affect alignment, so an alignment should follow any tie rod replacement.
The one-piece forged design is intended to reduce early wear compared with many two-piece original tie rods, and the hardened studs are built to resist more wear than original studs. Tie rods carry motion from the steering rack through the linkage to the steering arm or spindle.
The neoprene-sealed rubber dust boot resists extreme temperatures and abrasion. Its small valve lets old grease and contaminants be flushed out during service, which is useful on a Grand Cherokee that sees mud, dust or water crossings. Worn play in this joint should be addressed promptly, since a failed tie rod affects steering control.
Key features
- Passenger side upper outer position
- Forged one-piece unit, unlike many two-piece OE tie rods, which Moog says reduces early wear
- Neoprene-sealed rubber dust boot, resistant to extreme temperatures and abrasion
- Small valve in the boot allows old grease and contaminants to be flushed
- Hardened full-ball metal studs
- Direct-fit replacement
Signs of a worn tie rod
A worn tie rod end usually shows up as play in the steering. Lift the front wheel and check for movement at the joint by hand, and look at the rubber boot for tears, cracks or missing grease. A dry or split boot lets water and grit into the ball, which speeds up wear.
Other symptoms include wandering on the road, vibration through the wheel, clunking over bumps and tires that wear unevenly on the inner or outer edges. Any of these means the linkage should be inspected. Because the tie rod sets steering geometry, a new part should be followed by an alignment, and the joints on the other side are worth checking at the same time.
- Play at the wheel with the vehicle lifted
- Torn or cracked dust boot
- Clunking over bumps or uneven tire wear
- Wandering or loose steering feel
Specifications
| Brand | Moog |
|---|---|
| Part number | MOGES3474 |
| Part type | Upper outer tie rod end |
| Side | Passenger |
| Construction | Forged one-piece unit |
| Dust boot | Neoprene-sealed rubber boot with flush valve |
| Studs | Hardened full-ball metal studs |
| Fit type | Direct fit |
Vehicle fitment
It fits the 1999-2004 Jeep Grand Cherokee (WJ).
The ZJ (1993-1998) and WK (2005-2010) Grand Cherokees are different generations and are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Moog recommends having an alignment done immediately after replacing tie rods, because the part strongly influences alignment.










