Overview
It is a bolt-in front replacement housing for 2007 and up Jeep JK Wranglers with stock caster, suited to lifts of up to 4 inches. It is a high-pinion Dana 44 housing designed to handle loads that would normally bend a stock Dana 30 or a Rubicon Dana 44.
The housing accepts stock Dana 44 ring and pinion sets, axle shafts and aftermarket lockers. It uses metric carrier bearings that allow the factory air locker, and it has massive forged inner C-ends. The CORE 44 uses an adjuster nut system for setting backlash and carrier pre-load, with heavy-duty forged bearing caps.
Key features
- Front bolt-in replacement housing
- High-pinion Dana 44 gear design
- Stock caster for lifts up to 4 inches
- Metric carrier bearings that allow use of the factory air locker
- Massive forged inner C-ends and heavy-duty forged bearing caps
- Three-inch tubing with CNC-formed brackets
- Spanner nuts for backlash adjustment and an adjuster nut system for carrier pre-load
Preparing the housing
A bare housing is a shell until the gears, axle shafts and locker are installed, so the work starts on the bench. Clean the housing, check the bearing bores and carrier seats, and confirm the axle shafts and ring and pinion are a matched set before mounting. Starting with a clean, square housing makes backlash and carrier preload much easier to set.
Once mounted, pay attention to pinion angle, brake lines and driveline connections. The adjuster nut system gives fine control over carrier preload, so it is worth taking time over the setting. After the first miles of driving, listen for noise, check the fluid level and re-check the spanner nut settings, since they can shift as the parts settle.
- Clean and inspect bearing bores and carrier seats
- Confirm ring and pinion and shafts match before assembly
- Set preload with the adjuster nuts before final torque
- Re-check fluid and spanner nuts after early driving
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 67-2051JKF |
| UPC | 631410112740 |
| Position | Front |
| Housing type | CORE 44, high pinion, Dana 44 |
| Caster | Stock, for up to 4 inches of lift |
| Tube diameter | 3 inches, heavy-duty DOM tubing |
| Installation | Bolt-in |
Vehicle fitment
It fits the 2007 and up Jeep JK Wrangler, covering the 2007 through 2018 model years.
Lifts above 4 inches need the added-caster version, and Wrangler TJ, LJ and JL models are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The housing is bolt-in, but it arrives bare, so the ring and pinion, axle shafts and lockers are fitted before installation. Set backlash with the spanner nuts and check the setup after the housing is mounted.
What’s included
One bare front axle housing, part 67-2051JKF.
Not included: the ring and pinion gears, axle shafts and lockers, which are fitted separately.



















