Overview
The G2 CORE 44 front axle housing, part number 67-2051TJF, is a bolt-in replacement for the front axle of the 1997–2006 Jeep Wrangler TJ and the 2004–2006 Wrangler LJ Unlimited. It is designed for heavy loads, with its strength aimed at the bending a stock Dana 35 or Dana 44 sees.
The CORE 44 is built around the latest Dana 44 gear design and accepts stock Dana 44 ring and pinions, axle shafts and aftermarket lockers. The housing comes bare, so the gear set and axle shafts are installed separately. Use it with JK ring and pinion gears.
Key features
- Bolt-in replacement with a bare axle housing
- Three-inch heavy-duty tubing to resist bending
- Laser-cut and CNC-formed brackets for bolt-in installation
- Adjuster nut system for setting backlash and carrier pre-load
- Heavy-duty forged bearing caps
- Includes a G2 differential cover
Front axle build and setup
A bare axle housing is the start of a full front axle build, not a finished assembly. The ring and pinion, carrier, axle shafts, locker and brakes all go in separately, and each one affects the next. Setting backlash and carrier pre-load correctly matters for gear life and noise, so this work is best done with the gear set on a bench before the housing goes into the vehicle.
Clean the housing thoroughly and check the axle tube for damage before assembly. Use fresh gear oil at the correct fill level once the build is complete, and check the seals and bearings for wear. After the first few drives, listen for whine or clunks and re-check the pinion and carrier torque. Front axles are also a common place for driveline vibration, so check the joints and axle angles after installation.
- Clean the housing and inspect the tube
- Set backlash and pre-load with the adjuster nuts
- Use fresh gear oil at the correct fill level
- Re-check fasteners after the first few drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 67-2051TJF |
| UPC | 631410131796 |
| Housing type | Front, Dana 44 CORE 44 |
| Installation | Bolt-in |
| Tube diameter | 3 inches, heavy-duty DOM tubing |
| Carrier bearing and backlash | Spanner nuts for backlash adjustment |
Vehicle fitment
It fits the 1997 to 2006 Jeep TJ Wrangler and the LJ Wrangler Unlimited as a front housing.
JK, JL and YJ Wranglers, and Dana 35 front axles, are not covered by this housing. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The housing is a bolt-in replacement, but it comes bare, so the axle shafts and differential components must be fitted separately. Set backlash and carrier pre-load with the spanner adjuster nuts, and have a shop with axle experience check the setup, since the gear set is a full Dana 44 installation.
What’s included
One bare front axle housing with the G2 differential cover, part 67-2051TJF.
Not included: the ring and pinion gears, axle shafts, lockers and brakes, which are installed separately.


















