Overview
The J.E. Reel 1350 OE Replacement Rear Drive Shaft, part JER3518JL-4R, is a rear driveshaft for the 2019 Jeep Wrangler JL two-door with an automatic transmission. It is an original-equipment replacement built on the 1350 platform and is recommended for stock height up to a 2 1/2-inch lift, with tires up to 33 inches for mild use.
It is built to work with lifts up to 2 1/2 inches from most manufacturers, and measuring the driveline is good practice. On the 2018 JL the transfer case is installed at 9.25 degrees, which slopes the rear output down toward the axle.
Key features
- 1350 platform, original-equipment replacement
- Recommended for stock height up to a 2 1/2-inch lift
- Rated for tires up to 33 inches for mild use
- Extended length, direct fit
Rear driveline and tire changes
The rear driveshaft transmits power from the transfer case to the rear axle, and its length has to match the distance between them as the suspension cycles. Stock height keeps the joint angles close to what the driveline was built for. Once a lift raises the body, the angles grow and the shaft needs to be measured to confirm the length and travel are still within range.
Tire size affects the driveline more than many owners expect. Larger tires add rotating mass and load to the shaft and the axle, so changes in size should be considered alongside the lift height. Shoppers often replace a rear shaft together with the pinion seal or U-joint when a driveline is opened for service.
- Check the boot and joint for grease leaks
- Look for vibration that rises with speed
Specifications
| Brand | J.E. Reel |
|---|---|
| Part number | JER3518JL-4R |
| Position | Rear |
| Transmission type | Automatic |
| Length | Extended |
| Recommended lift | Stock to 2 1/2-inch |
| Tire size, mild use | Up to 33 inches |
| Fitment type | Direct fit |
Vehicle fitment
It is a direct fit for the 2019 Jeep Wrangler (JL) two-door models.
Four-door JL models are not in this fitment entry, and the 2018 JL needs its own angle check. Confirm your vehicle’s year, model and trim before choosing this part.
Installation notes
Lifts above the stated range or long-arm lifts need a driveline length measurement before installation. Measuring all drivelines where possible is good practice.
What’s included
One rear driveshaft assembly.









