Overview
The 92-2150-1 is an extended length CV front driveshaft for the 2018–2020 Jeep Wrangler (JL) Sport with an automatic transmission. It fits the Sport and Sport S in 2-door form, and the Unlimited Sport and Unlimited Sport S in 4-door form.
The shaft is built from heavy duty D.O.M. tubing and uses solid body 1350 series u-joints. It is dynamically balanced to reduce vibration. No slip yoke eliminator is needed for it to fit.
The length is extended, so check it against the transfer case output and front axle before ordering.
Key features
- Front position for the Wrangler JL Sport models
- Automatic transmission application
- Heavy duty D.O.M. tubing
- Solid body 1350 series u-joints
- CV joint design
- Dynamically balanced
- Extended length
Choosing a front driveshaft
A front driveshaft is shaped by the transfer case output, the front axle pinion and the suspension geometry under it. Length is the main variable, and an extended shaft suits a setup where the factory length no longer reaches the right angles. Before buying, measure the distance between the transfer case output and the axle pinion, and compare it with the shaft’s stated length. Keep joint angles moderate, since sharp angles increase vibration and joint wear.
Installation and inspection go hand in hand. Check the joints for play after the first drives, listen for clicks when turning, and look for grease seepage around each joint boot. Replacing worn joints together with the shaft keeps the driveline working as a matched set, which is often the simplest way to avoid repeat vibration problems on the trail.
- Measure transfer case to pinion distance before ordering
- Check joint angles after any suspension change
- Inspect boots and joints after rough trail use
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 92-2150-1 |
| Position | Front |
| Transmission type | Automatic |
| Length | Extended |
| Joint type | CV |
| Tubing | Heavy duty D.O.M. |
| U-joints | Solid body 1350 series |
| Slip yoke eliminator | Not required |
| Fitment type | Direct fit |
Vehicle fitment
It fits the 2018–2020 Jeep Wrangler (JL) Sport and Sport S in 2-door form, and the Unlimited Sport and Unlimited Sport S in 4-door form.
Confirm fit for your vehicle’s year, model and trim before ordering, especially for the Rubicon, the 2021–2022 Wrangler JL and the Gladiator.
Installation notes
No slip yoke eliminator is needed for this shaft. Check the extended length against the transfer case output and the front axle pinion before installing, since a length error would change the joint angles.
What’s included
The front driveshaft assembly is included, with no separate hardware.













