Overview
The G2 GM 12 bolt 9.5-inch and 9.76-inch aluminum differential cover, from G2’s Brute line, is made for GM 12 bolt rear axles with those widths. It is cast from heat-treated A356.0-T6 aluminum and is fitted with a fill level plug that works for both high and low pinion axles.
The covers are shot peened to help them take direct impact, and ball milled cooling fins help dissipate heat from the gear oil. The satin black powder coat is ultraviolet resistant, and the cover is fully clear-coated for corrosion protection. The warranty runs 10 years.
Cast aluminum covers like this one give up some of the strength of steel in exchange for lower weight and better heat transfer, and the ball milled fins increase the surface area that sheds heat. The fill level plug is the reference point for topping up the gear oil.
Key features
- Heat-treated A356.0-T6 cast aluminum, shot peened
- Ball milled internal and external cooling fins
- Satin Black, ultraviolet-resistant powder coat
- Fully clear-coated for corrosion protection
- Fill level plug for both high and low pinion axles
Checking gear oil and fill level
The fill level plug is the reference point for topping up the gear oil, so the level should be set with the cover in its final position. Fill slowly and let the oil settle before checking the level. Use fresh gear oil, and make sure the oil type matches the gears and any limited slip additive used in the axle.
Aluminum covers shed heat faster than steel, which helps the gear oil stay in a steadier temperature range under load. That benefit only lasts if the cover is clean, the fins are free of mud, and the seal area is free of old gasket material. Inspect the cover after each trail season and check for scratches in the coating that could start corrosion.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Axle location | Rear |
| Axle type | GM 12 bolt 9.5 inches |
| Material | A356.0-T6 cast aluminum |
| Oil capacity | Extra capacity |
| Finish | Powder coated, Satin Black |
| Warranty | 10 years (G2) |
Vehicle fitment
This cover is an axle part, sized for GM 12 bolt rear axles of 9.5-inch and 9.76-inch width. It is not vehicle-specific, so check the axle width before ordering.
Installation notes
The seal surface is fully machined for a leak-free installation, and the fill level plug is set for both high and low pinion axles. Confirm the pinion type on your axle before filling.


















