Overview
The G2 Chrysler 9.25-inch front aluminum differential cover is made for Chrysler 9.25-inch front axles. It is cast from lightweight aluminum and finished in black powder coat, with ball milled reinforcing ribs.
The cover guards the ring and pinion and helps cool the gear oil. It is heat treated and shot peened for resistance to direct hits, and the seal surface is fully machined.
Front covers take the same trail hits as rear covers, so the ribbed, heat treated aluminum construction is what protects the ring and pinion. The seal surface is fully machined for a leak-free installation, as G2 states.
The cover is cast from lightweight aluminum, and its black powder coat and ribs are the features G2 lists first.
Key features
- Ball milled reinforcing ribs
- Heat treated and shot peened
- Fully machined seal surface
- Convenient filler plug and fill level plug
Fluid level and seal care
A differential cover is the lid that keeps gear oil in and dirt out, so its condition affects the whole axle. Aluminum covers are light and shed heat well, but they can dent when they take a hard strike on the trail. Inspect the ribs and the mounting flange after rough runs for cracks or bent edges.
Whenever the cover comes off, replace the gasket and clean both mating surfaces before reassembly. Tighten the bolts evenly in a crisscross pattern so the seal compresses without distortion. After the first few drives, look for seepage at the seal and top off the gear oil to the fill level.
- Inspect for dents near the reinforcing ribs
- Replace the gasket every time the cover is removed
- Check fill level with the vehicle level
- Look for seepage after the first drives
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Axle location | Front |
| Axle type | Chrysler 9.25 inches |
| Material | Aluminum |
| Oil capacity | Extra capacity |
| Finish | Black powder coat |
Vehicle fitment
This is an axle part for Chrysler 9.25-inch front axles, and it is not vehicle-specific. Check the axle type before ordering.
Installation notes
The fill level plug is designed for both high and low pinion axles, so it can be used whichever pinion type the front axle has.






















