Overview
The G2 Dana 30 Brute aluminum finned differential cover (part number 40-2031MB) is a front cover for Dana 30 axles. The specifications list the Dana 30 JK, Dana 30 Reverse, Dana 30 Standard and Dana 30 TJ designs.
The cover is cast from lightweight aluminum with a black powder coat finish. The ball milled ribs and finned design help dissipate heat from the gear oil. It is heat treated and shot peened to protect the ring and pinion from direct hits.
Ball milled ribs and the finned design are the cooling features of this cover, and the seal surface is machined so the cover sits flat against the housing.
Key features
- Ball milled reinforcing ribs for rigidity
- Heat treated and shot peened to handle direct impact
- Fully machined seal surface
- Convenient filler plug and fill-level plug
Setting the gear oil level
Gear oil level is set through the fill plug, so the cover’s plug design matters for regular service. Setting the level to the correct mark keeps the gears lubricated without overfilling, which can push oil past the seals. Use a fill pump or a suitable tool that reaches the plug, and wipe the cover area before opening it.
Differentials run hot under load, so keep an eye on oil condition during routine service. Dark or metallic oil can mean internal wear, while a leak around the cover gasket points to a loose bolt or a worn seal. Clean the sealing surface before reinstalling the cover to help it seat flat.
- Check oil level after the first few drives
- Replace the cover gasket if it is damaged
- Inspect cover bolts for looseness
- Use gear oil that matches the axle’s specification
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 40-2031MB |
| Axle location | Front |
| Axle types | Dana 30 JK, Dana 30 Reverse, Dana 30 Standard and Dana 30 TJ |
| Material | Aluminum |
| Oil capacity | Extra capacity |
| Finish | Black powder coat |
Vehicle fitment
This is an axle part for Dana 30 front axles, not a vehicle part. Check the axle type before ordering.
Installation notes
The fill-level plug is designed for both high and low pinion axles, so the fill level can be set on either type of Dana 30 pinion.
















