Overview
The G2 Axle and Gear 2-2044-456 is a 4.56 ratio ring and pinion for the Toyota 9.5 Inch axle, sized for the Toyota Land Cruiser. The pinion turns 4.56 times for each full turn of the ring gear, a numerically high ratio that multiplies torque at the wheels.
G2’s Performance line is built for oversized tires and high-performance engines, using current materials and manufacturing methods. This 4.56 set is made for Toyota 9.5 Inch axles in both front and rear positions. Measure the axle housing and carrier to confirm the match for your vehicle.
Key features
- 4.56 gear ratio for the Toyota 9.5 Inch axle
- Fits front or rear 9.5 Inch axles
- Ring gear and pinion supplied as one set
- Designed for oversized tires and high-performance engines.
- Made with current materials and manufacturing methods.
Carrier and preload basics
A 9.5 inch ring and pinion is only half of the drivetrain upgrade. The carrier holds the ring gear and sets its position against the pinion, so the carrier bearings and preload matter as much as the teeth. Worn carrier bearings can let the ring gear shift, which causes whine, clunks and uneven tooth wear even when the new gears are correct.
When choosing a ratio for a larger tire or a heavier build, think about how the vehicle is mostly driven. A numerically high ratio helps low-speed pulling and crawling, while higher ratios also raise engine speed on the highway. Gear sets are often replaced together with bearings, seals and the pinion crush sleeve or spacer, so check those parts while the axle is open.
After installation, listen for noise during light throttle and coast, and recheck the fluid level after the first few drives. Inspect the fluid for metal flakes at regular service intervals, and keep a record of what was replaced so later work is easier to plan.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2044-456 |
| UPC | 631410094404 |
| Axle type | Toyota 9.5 Inches |
| Axle location | Front or rear |
| Gear ratio | 4.56 |
| Axle manufacturer | Toyota |
Vehicle fitment
This 4.56 set is made for the 9.5 inch Toyota axle, front or rear. Confirm the axle size, the axle position and the carrier on your Land Cruiser before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
A 9.5 inch gear set needs correct pinion depth, backlash and carrier preload, which a gear shop can set with the right tools. Plan for a break-in period before heavy loads.
What’s included
One 4.56 ring and pinion set for the Toyota 9.5 Inch axle, part number 2-2044-456.
Not included: Carrier bearings, shims and installation hardware.















