Overview
It is a 3.73 ratio ring and pinion for GM 10 Bolt rear axles. The pinion turns 3.73 times per ring gear revolution, a ratio that gives more pulling force at low speed than a numerically lower gear. It is offered for both the 7.5 inch and 7.625 inch ring gear versions of the 10 Bolt.
G2 says its Performance Ring and Pinion line handles oversized tires and high-performance engines and uses current manufacturing methods. No vehicle models or years are named. The GM 10 Bolt housing, with its ring gear diameter, is what the buyer needs to confirm.
Key features
- 3.73 gear ratio for GM 10 Bolt rear axles
- Covers the 7.5 inch and 7.625 inch ring gear sizes
- Ring gear and pinion sold as one matched set
- Designed for oversized tires and high-performance engines.
- Rear axle location
Setting up a 3.73 gear set
A ring and pinion set only works as well as the parts around it. Before a 3.73 set goes in, inspect the carrier bearings, pinion seal and differential case for wear, since new gears running on worn components tend to get noisy and wear quickly. Replace the bearings and seals as part of the job when the old ones show play or leaks. Clean the housing thoroughly so no old metal or debris stays behind.
Tire size changes how the ratio feels. Taller or wider tires add load on the gears and effectively shift the ratio lower, so a 3.73 set suits a rig where low-speed pulling matters more than highway fuel use. Drivers who mostly cruise on the highway with stock tires may notice higher engine speed than expected. Track how the vehicle feels over the first few weeks, and note any whine under light throttle, which can point to setup rather than wear.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 2-2015-373 |
| UPC | 631410093490 |
| Axle type | GM 10 Bolt, 7.5 inch or 7.625 inch ring gear |
| Axle location | Rear |
| Gear ratio | 3.73 |
| Axle manufacturer | GM |
Vehicle fitment
Confirm fit by measuring the ring gear and checking the carrier on your vehicle before ordering. This set is made for GM 10 Bolt rear axles, and axles outside the 10 Bolt family are not a match.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Pinion depth and backlash decide how a 3.73 set wears in, so most installers rely on a gear shop’s setup procedure. Expect a break-in run before loaded towing.
What’s included
One 3.73 ring and pinion set for GM 10 Bolt rear axles, part number 2-2015-373.
Not included: Carrier bearings, shims and installation parts are not included with the 3.73 GM 10 Bolt set.
















